Electrolux EQE5607 User Manual page 21

Step 2 Connect tap fitting to water supply tap.
Tap must be close to the refrigerator.
Step 3 Push the tube into tap fitting past
insertion mark.
Step 4 Connect other end of tube to inlet on
rear of refrigerator.
Step 5 Turn on water and check all joints and
tubes for leaks.
Step 6 Reconnect the power.
Step 7 Move the refrigerator back into place
being careful not to kink or split the tubing.
Step 8 Switch ON Water
Dispenser. By referring
to Ice & Water on/off
function. Using a large
container, run the water
dispenser to clear air
from lines. This may take
a few minutes. Purge and
dispense a minimum of 2
litres of water. Initial water
may be black in colour.
This is residual carbon dust from the filter and
is non-toxic. If the water is slow to shut off or
the dispenser is dripping, air may still be in
the lines. Either purge more water through the
system to remove this air or allow some time
for the air to be removed over subsequent
dispensing. For normal use, water dispenser
will automatically shut off after 2 minutes of
continuous operation.
IMPORTANT
As the water cut off is not instant, leave
glass under dispenser briefly until water
has stopped flowing to avoid spills.
Clean and empty the dispenser drip tray
regularly to avoid overflow.
Flushing system about 2 minutes after
period of non-use exceeding 30 days.
Step 9 Switch ON Ice Maker.
Once the refrigerator has been running for at
least 24 hours remove the ice bin and dispose
of the first few batches of ice to ensure that
impurities have been flushed from the system.
CAUTION
Water dispenser should not be used for
extended periods of time. After 2 minutes
of continuous use the water dispenser
will automatically shut off.
Party Ice
When the Ice Bin is removed from the cabinet
the Auto Ice Maker will continue to dispense ice
into the top freezer drawer.
IMPORTANT
• Always fit the filter as per manufacturer's
instructions.
• If you need to replace water tube, only
use approved water quality piping that
meets the pressure requirements.
• Make sure your refrigerator is level to
avoid uneven ice cubes.
• Replace filter at suggested intervals
to avoid water/ice reduction and
irregularities in taste.
• Remove and clean ice bin once a
month, discarding unused ice cubes.
This will ensure fresh, clean ice and
smooth operation of your ice maker.
• Clean and empty the dispenser drip
tray regularly to avoid overflow.
21
EN