Table of Contents
Advertisement
3. PRESET ENABLE/DISABLE
Permits selection of the number of presets required.
A Main PWS is capable of up to 70 presets (Model# PWS-70P-DMX) or 20
presets (Model# PWS-20P-RETRO). Both versions are shipped from the factory
with only the first 10 presets enabled. To enable more or less presets and select
color choices:
a) Enter your ADMIN PASSWORD.
b) Select the PRESET ENABLE icon in the settings menu.
c) A different color has been factory set for each group of 10 presets.
d) Touching the preset will enable it and touching again will DISABLE it.
ENABLE the number of presets desired for the room.
e) After the Main PWS presets have been synchronized with any Secondary
PWS connected to the room Main PWS, the above process can be repeated
at each Secondary PWS as desired. Secondary PWS can only access the
presets available in their room Main PWS and cannot exceed the number of
presets available at their respective room Main PWS. However, Secondary
PWS's can be limited to as few as one single large button preset permitting
customization of Secondary PWS's within any given room/zone. Selection of
4 or fewer presets at a PWS will increase the physical pad size of the preset
and increase the contact surface area of preset activation.
4. DATE/TIME - Set the date and time and permit choice of display in
various formats. USER and ADMIN PASSWORD access permitted.
5. SYNC AND LOCK - Synchronize all Secondary PWS connected to
the room Main PWS. Relevant data will be shared from the Main to the
Secondary PWS (maximum 14 Secondary PWS per room). ADMIN
PASSWORD required to access.
SYNCing the Secondary PWS, shares all the required data to them in a single
button push. The following pop screen displays for approximately 2 seconds
during the data transfer from the Main PWS to the Secondary PWS.
Secondary PWS stations can also be locked out in this menu by pushing the
Lock button. When locked the icon will change from green to red.
Secondary PWS within a room can also be locked out for safety at the Main
PWS. Pressing the LOCK icon will toggle between a LOCK and UNLOCKED
state.
In a multi-room environment where the PRESETs and LABELS are the same in
several rooms, the programmed data from one Main PWS can be "shared" to
other room Main PWS by pushing the "ROOMS" sync button. This can save a lot
of time during an initial commissioning. This feature is still in development and
will require a Presidor™ PRLC-4 (Room Linker Combiner).
22
WWW.JOHNSONSYSTEMS.COM
Advertisement
Table of Contents
