Wren SDP6 Install Manual

Ip-enabled 6” solution dome

Advertisement

Quick Links

SDP6-IP, IP-Enabled 6" Solution Dome

Overview

The IP-Enabled Pendant Solution Dome line delivers attractive, durable products
for indoor security. Solution Domes are an excellent value----- -well-built, well-
priced and designed for easy installation and maintenance.

Suggested Installation Equipment

#2 Phillips-head screwdriver
Pliers (optional, for DC power)
Component List [Figure 1]
A. Upper Housing Assembly
B. Encoder Module
C. Fixed Camera Bracket
D. Three-Piece Camera Mounting Bracket
E. 6'' Dome Assembly
F. Power Lead Extension and Connectors (not shown)
G. Wing Screw (not shown)

Warnings and Safeguards

Prior to installation and use of this product, please observe the
following warnings
1. Installation and servicing should be done by qualified personnel,
and all work done should conform to local codes.
2. Using replacement parts or accessories other than Wren may
invalidate the warranty.
3. This unit is designed to operate on either IEEE 802.3af POE or 12VDC
power. Do not bring any other voltages into the housing.
4. Make sure that the installation method is capable of supporting three
times the weight of the SDP6-IP housing and enclosed contents.
5. Verify proper installation of cabling to support camera power and
communication requirements for fixed camera applications.

Preparation

1. Carefully unpack box and verify that all components listed are included
[Figure 1].
2. Remove the Dome and Trim Ring Assy from the upper housing by turning
the assembly counter-clockwise, taking care that dome does not become
scratched or damaged.
3. Remove the fixed camera bracket and the three
bracket by removing the 3 wing nuts securing it to the SDP6 housing.
4. Run CAT5 (and, optionally, 12VDC leads) to the location where the
assembly is to be installed.
POE power must be IEEE 802.3af compliant. Optional 12VDC power must be from
NOTE
a regulated power source and of the correct polarity (center positive). (See Master
Power Supply Instructions for wiring/installation instructions.)
www.wrenassociates.com
(3)
(3)
piece mounting
(800) 881-2249
Indoor IP Solutions:
SDP6-
IP
6" Solution Dome
FIGURE 1
7L257-revA 9/1/2006
Page 1 of 3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SDP6 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Wren SDP6

  • Page 1 3. Remove the fixed camera bracket and the three bracket by removing the 3 wing nuts securing it to the SDP6 housing. 4. Run CAT5 (and, optionally, 12VDC leads) to the location where the assembly is to be installed.
  • Page 2 SDP6-IP, IP-Enabled 6” Solution Dome Installation 1. Install SDP6 assembly on 1½’’ NPT pipe or mount by rotating counter-clockwise until threads are fully engaged. 2. Reinstall the fixed camera bracket and the three bracket. 3. Connect the CAT5 cable to the RJ45 jack on the IP encoder sub- assembly inside the housing.
  • Page 3: Specifications

    Up to 95% RH (non-condensing) All Products Are Subject to the Current Version of Wren Terms and Conditions WARRANTY INFORMATION Wren warrants SDP6-IP housing for five (5) years and the camera and all other electronics for one year from the purchase date, recorded as the ship date on Wren’s invoice,...

This manual is also suitable for:

Sdp6-ip,

Table of Contents