Wolf WWD30 Use & Care Information Manual page 12

W O L F
C A R E
C O M P O N E N T
Drawer Front
(stainless steel)
S I G N AT U R E
P O L I S H
Signature Polish
is available from
Signature Limited
Laboratory,
P. O. Box 13436,
Dayton, Ohio
45413-0436, or
call 877-376-5474
(toll free).
Drawer Pan
(stainless steel)
Drawer Rack
(chrome)
Control Panel
(polycarbonate)
12
WA R M I N G D R AW E R
R E C O M M E N D AT I O N S
C A R E R E C O M M E N D A T I O N
Although stainless steel is resistant to most stains, it is not totally
impervious to damage. Salt and some cooking liquids may pit and stain
the surface. Always remove these spills immediately.
Exterior Cleaning: To clean the exterior of a classic or platinum stainless
steel model, use a soft, nonabrasive stainless steel cleaner like Signature
Polish (see side note) and apply with a soft lint-free cloth. Carbon
stainless steel can be cleaned with mild soap and water.
To bring out the natural luster of all three finishes, lightly wipe the surface
with a water-dampened microfiber cloth, followed with a dry microfiber
cloth. All work should follow the grain direction of the finish. Better results
are obtained by keeping the cloth in continuous contact with the metal.
Spray degreasers: Remove fingerprints and greasy spatters. Spray on a
cloth and wipe surface. Buff dry immediately to avoid streaking.
Hard water stains: Use white vinegar and water.
Do not use abrasive cleaners (e.g., Comet or Soft Scrub); they will perma-
nently scratch the surface. Do not use steel wool pads.
Under no circumstances should you use a metallic or highly abrasive
cleaner or cloth, as this will remove the carbon finish.
Although stainless steel is resistant to most stains, it is not totally
impervious to damage. Salt and some cooking liquids may pit and stain
the surface. Always remove these spills immediately.
Spray degreasers: Remove fingerprints and greasy spatters. Spray on a
cloth and wipe surface. Buff dry immediately to avoid streaking.
Hard water stains: Use white vinegar and water.
Do not use abrasive cleaners (e.g., Comet or Soft Scrub); they will perma-
nently scratch the surface. Do not use steel wool pads.
General Care: Clean the rack with a mild detergent and water. After
cleaning, rinse with clean water and dry thoroughly with a clean cloth.
General Care: Be careful not to soak the control panel. Although they are
sealed, excessive moisture may still cause damage to the controls.
Use a glass cleaner to remove fingerprints, spills, etc. from the surface of
the control panel. Spray first on a cloth before wiping panel.
IMPORTANT NOTE: Make sure the warming drawer is off and all surfaces
are cool before cleaning any part of the unit.
U S E & C A R E