Auto Operation Functions - Philips VR455 Manual

Auto Operation Functions
Auto Playback
When a tape is inserted, the power comes on.
If the record tab* is removed, playback begins.
Auto Rewind
When a tape reaches its end during playback, fast forward, or manual
record, the VCR rewinds the tape and goes into Stop mode.
Memory Rewind Power Off
When the POWER button is pressed during rewind, the VCR will
turn off after rewind is complete.
Eject Cassette
A cassette may be ejected with power on or off.
* For record tab information, refer to page 6.
Auto Tracking Control
With Auto Tracking there is usually no need for manual adjustments
to minimize noise in playback for most tapes. Auto Tracking
continuously analyzes the signal to adjust for optimum picture
quality for each recording. However, with some recordings you may
get a better result using the TRACKING UP/DOWN buttons.
Manual Tracking Controls
Press the TRACKING UP/DOWN buttons.
Use Manual Tracking adjustment during playback, slow motion, and
double speed playback to minimize noise in the picture.
Also, use these buttons to reduce jitter in a still picture. Once you
make this adjustment, you probably will not have to do it again —
unless you select Still mode while playing a tape recorded on a
different VCR.
To cancel manual tracking, stop the tape, eject the tape, then re-insert
it. Each time a tape is inserted automatic tracking is engaged.
POWER
= Sa ae UP/DOWN Buttons
PHILIPS
Remote Control