Start / Warm Up Procedure - BMW M2 CS RACING 2020 Driver Manual

APPENDICES.
A. START / WARM UP PROCEDURE.
Type of check
Pre-Checks
Warm Up
BMW M2 CS RACING 2020 I DRIVER MANUAL I BMW M MOTORSPORT I V02 I AUGUST 2023
Check ID AM WU
1 X X
2 X X
3 X X
4 X X
5 X X
6 X X
7 X X
8 X X
9 X X
10 X X
11 X X
12 X
13 X
14 X
15 X
16 X
17 X
18 X
19 X
20 X
21 X
22 X
23 X
24 X
Sequence
Possibly connect car battery.
Connect charger or jump battery at the jump start connector in the fuel filler cap.
Check engine oil level at the dip stick (min. 2 hours no engine running before).
Check coolant level in both reservoirs (Engine and Intercooler).
Check brake fluid level in both reservoirs.
Jack up the car with air jacks.
For a safety stand use "Safety's"!!!
Check car for fluid leakage.
Visual check of all suspension components for cracks and damages.
Remove "Safety's" !!!
Put back the car on ground with air jacks.
Switch Main Switch on Switchbox to „ON".
Do not touch brake pedal !!!
Push start button once to >>> Ignition ON.
Read error codes memory and delete.
Gearbox unlocking lever in „Park" position.
Press „P"-button on Switchbox >>> Check AIM-Display.
Push brake pedal !!!
Press Start button >>> Engine cranks and starts.
Keep engine idle until engine water temperature reaches 40 °C.
Rev up to constant 2500 - 3000 rpm until engine water temperature reaches 80 °C.
Initiate steering angle sensor >>> Turn steering wheel lock to lock.
Push Start/Stop button on Switchbox >>> Engine stops.
Read error codes memory and delete.
Page 89