Charcoal Filter.52 - AEG HL 7275 Operating And Installation Instructions

Dishwasher
Place grease filters in the dishwasher. Select most powerful
washing programme and highest temperature, at least 65°C.
Repeat the process. Refit the grease filters when they are dry.
When washing the metal grease filter in the dishwasher a slight
discolouration of the filter can occur, this does not have any impact
on its performance.
• Clean the inner housing using a hot detergent solution only (never
use caustic detergents, abrasive powders or brushes).
Charcoal filter
• The charcoal filter should only be used if you want to use the hood
in the recirculation function.
• To do this you will need an original charcoal filter (available from
your local Service Force Centre).
• This filter cannot be cleaned or reused.
• As a general rule, the charcoal filter(s) should be changed
once every four months.
• Fitting.
Remove the frame pushing the two side release keys "a".
Fig. 5a-b.
Fit each charcoal filter so to cover the plastic grid that
protect the fan wheel, then turn clockwise the central handle
of the charcoal filter. Fig. 6.
Refit the frame (snap into place).
• To remove proceed in the reverse order.
• Always specify the hood model code number and serial number
when ordering replacement filters. This information is shown on the
rating plate located on the inside of the unit.
• The charcoal filter can be ordered from your local Service Force
Centre.
Fig. 6
52