Kenwood TK-701S Service Manual page 45

7018
LL UNIT (X61-1190-22) | | PLL UNIT (X61-1190-22)
erminal functions | Printed Circuit Board
'onnector} Terminal | Terminal ; ; Connector| Terminal | Terminal ; ;
No. No. name Terminal function No. No. name Terminal function
P14 1 ESP External speaker input 11 OPT.1 Spare
2 C8 8V common power source line 12 OPT.2 'Spare
3 SB Switched B to regulated power source 13 OPT.3 Spare
4 KEY TX/RX data input (L for TX; H for RX) 14 OPT.4 Spare
5 R8 8V when receiving 15 T8 Approx. 8V when transmitting
h ae
6 T8 | 8V when transmitting J7 1 S1VIO | Channel switch 1
7 AVO Audio output from AF volume ;
, 2 S2BLU Channel switch 2
8 AVI Audio input to AF volume
, 3 S3GRN | Channel switch 3
9 AFO Audio signal output a
10 NSO Noise squelch output 4 S4YEL Channel switch 4
4 NSI ve a ch - , 5 | S5ORG | Channel switch 5
olse squeren ines 6 S6RED | Channel switch 6
12 AFI Audio signal input 7 C BRN 5V common line
13 MUT Mute signal input
14 QTD Quiet Tone Disable input J8 1 $1 VIO | Channel switch 1
15 AC Audio Control output 2 S2 BLU | Channel switch 2 5
16 UNL Unlock signal output 3 S3 GRN | Channel switch 3 x
4 S4 YEL | Ch | switch " o> P2 1 B Transmitting final Bt anne! switch 4 m 2
og 5 S5 ORG | Channel switch 5 —- Iq
2 B Transmitting final Bt m Ix
ae 6 S6 RED | Channel switch 6 Q |2
3 B Transmitting final Bt xo wm 'In |o
. 7 C BRN 5V common line oO ja o [| |S {>
4 B Transmitting final Bt D yy
J9 1 BO BLU | ROM address input a Sm
J3 1 A Microphone PTT grounded aceress npe 5 3 r
2 B1GRN | ROM address input
2 PTT Microphone PTT input
3 B2 YEL | ROM address input . mM
3 MIC-L Microphone grounded ;
4 MIC-H1 Microohone input 1 4 B3 ORG | ROM address input
'low mpedancel 5 | B4RED | ROM address input e |o
6 5V BRN | 5V li
5 MIC-H2 | Microphone input 2 common ine
(high impedance) J10 1 TXO Transmit local signal output to TX/RX @
6 SPARE 1 | Spare unit
7 BASE MIC| Base Mic 8V DC 2 GND GND
T MIC hang-u
8 0 nowe Ju 1 BZBLU | Audio output
J4 1 At Bt for reception only 2 GND GND
(REC) (when internal jumper is cut) 2 RXO Receive local signal output
RX MUT | RX MUTE signal output shield to TX/RX unit
3 ESP-H External speaker output
4 FLTED Audio output bypassed volume
VOL. control
SQ-H
5 SPARE | Spare (GND) Jumper wire function
(A-)
6 A~ GND JU Cut off during key control by signalling unit.
7 ESP-L External speaker GND (-) JU2 x Short-circuits the CTCSS AF signal input and output
8 A~ GND terminals.
) QTD Quiet Tone Disable contro! JU3 Cut off during key control by timer-out timer.
10 SPARE | Spare (B line input: 13.6V) JU4 Outputs AVI signal.
11 At B* line input (13.6V) JUS x | Grounds the QTD.
J5 1 GND GND JU6 Cut off when using Rx power supply.
2 BZ | Beéper line input JU7 Grounds the spare terminal. |
3 C8 8V common power source line JU8 Connects the power and spare terminals.
4 KEY TX/RX data input (L when transmit- JUS A Installed in TK-7018S. Determines the
ting; H when receiving) JU10
A Installed in TK-801S.
Tx-PLL dividing
; 5 PTT Microphone PTT input JU11 A Installed in TK-701S. ) ratio.
JUI2 Cut off to disable the duplex.
J6 1 GND | GND JU13 x | Install to disable the QTD reverse circuit.
2 DET RX CTCSS input JU14 x Install to convert the 16CH unit to duplex.
' 3 AFI Audio Frequency signal input
4 AC Audio control output
5 -AFO Audio output x indicates jumper wire not supplied.
6 SB Switched B to regulated power source soe i
7 MOD Tone signal output
8 KEY TX data output (L when transmitting;
H when receiving)
9 PTT Microphone PTT input
10 C8 8V common power source line .