LG 55WT30MS Service Manual page 14

4.7. Outgoing condition Configuration
· When pressing IN-STOP key by SVC remocon, Red LED are
Press IN-STOP key by SVC remocon. And then automati-
cally turn off.
4.8. Hi-Pot test
Confirm whether is normal or not when between power
board's ac block and GND is impacted on 1.5kV(dc) or
2.2kV(dc) for one second.
4.9. Touch Controller Check
A. Execute the MTC.exe (If "MTC.exe" can't execute, Install
the ".Net Framework 3.5")
B. Plug a USB cable into a USB port on the Multi-Touch Con-
troller. Then, connect the USB cable to your PC (You must
turn on the Power to the Monitor)
C. Press the Start Button
D. Confirm the test result.(OK / NG)
* Touch Device ID
Inch Vendor
ID(VID)
42" 0x43E
47" 0x43E
55" 0x43E
* Name of the LGE Multi-Touch Information (MTC)
1) the Information of the Touch Controller
2) Start Button (Hotkey : 1 or Enter)
3) Result (OK / NG )
4) Process state
5) Exit
- OK
- NG
Copyright © LG Electronics. Inc. All rights reserved.
Only for training and service purposes
Product
ID(PID)
0x9AA1
0x9AA2
0x9AA3
4.10. Touch test
1) Execute the MTVP(Multi Touch Verify Program).exe
* When a pop-up window appears, select the touch model
inch.
2) Plug a USB cable into a USB port on the back of the
monitor. Then, connect the USB cable to your PC so that it
automatically recognizes the touch screen monitor.
3) The MTVP automatically operates.
(If The MTVP automatically doesn't operate, Push "Start" but-
ton )
* When the "Draw a long line in touch screen" is displayed.
4) Confirm the test result.
* Result
→ PASS
→ NG
- 14 -
LGE Internal Use Only