Advertisement
N (Continued)
DESCRIPTIO
CHANNEL
DISPLAY
Displays the current channel the radio is
operating
on.
the appropriate button(s) on the keyboard.
IV.
INSTALLATION
The radio is designed for mobile operation in
a vehicle with a 12V negative ground system.
wire (with in-line fuse) is connected to the positive
battery terminal and the black wire connected to the
negative
battery
Mount the radio in an accessible but not cramped
area.
Allow a few inches clearance on the right side
to allow the transmitter's heat to dissipate.
Mount the microphone hang-up clip in a con-
venient location making sure the clip is grounded.
In many new vehicles with a plastic dashboard, it
may be necessary to add a ground wire to the clip to
insure a good ground connection.
It is recommended that the radio and antenna
installation be performed by a technician experienced
in
two-way
radio
WARNING:
The FCC requires that the transmitter be
adjusted and set on frequency by a technician holding
a
general
radiotelephone
NOTE:
The transceiver is equipped with reverse
polarity
protection.
are reversed the fuse will blow; connect the power
leads to the correct polarity and install a new
The channels are selected by pressing
terminal.
installation.
license.
In the event that power leads
The red
Advertisement
