Table of Contents
Advertisement
DuraTherm®
clearance on all sides of the charger for cooling.
Do not place over paper or loose material that
may inhibit air flow into the bottom air intakes.
®
Consider the Dinex
product) DXPICTABLEM (Mobile with casters)
DXPICTABLE (Not mobile).
®
3. The DuraTherm
induction charger is equipped
with a locking plug. This plug is part of a system
that will protect you from injury in the event of an
electrical malfunction inside the unit. Be sure the
plug is fully plugged into a matching socket that is
properly grounded.
! ATTENTION: DO NOT cut or break off the larger
angled prong on this plug or change the plug or power
in any way. Doing so will create a safety hazard and
will also void the warranty.
4. CONFIRM
THAT
MATCHES THE CHARGER. The charger must
be plugged into a grounded 208V 3-phase, 20A
dedicated
NEMA
dedicated electrical outlet is required for EACH
®
DuraTherm
charger. Make sure that your
®
DuraTherm
Charger
energized circuit.
! CAUTION: A product identification label on the
bottom of the unit specifies the operating voltage,
current, frequency, phase, and maximum wattage of
the charger. Plugging or wiring the charger into less
voltage than the charger is rated may significantly
decrease the performance of the unit or damage
internal electrical components.
! IMPORTANT: Each charger should be connected
to its own dedicated circuit. They should not be
connected to circuits sharing compressors or other
heavy current draw devices (i.e., plate heaters, steam
tables, etc.)
5. Do not use any DuraTherm
damaged cord or plug. Consult the warranty and
follow the instructions for service.
6. Do not move the DuraTherm
electrically connected.
®
2023 CFS Brands- Dinex
| Oklahoma City, OK 73131
www.cfsbrands.com
| 800.654.8210
Induction Stand (Accessory
INCOMING
VOLTAGE
L15-20R
receptacle.
is
plugged
into
®
charger that has a
®
Charger when it is
7. Do not place foreign objects on the charger, or
between the Dinex
surface. Foreign objects may heat within the
induction field and cause damage to the charger
surface and/or base.
8. A grease filter is mounted to the bottom of the
unit. Assure the filter is seated and free of
excessive debris or grease. For replacement
filters order DXPLE9560.
9. Do not let the power cord touch hot surfaces.
10. The center of the charger may get hot to the touch
after hours of continuous use. Use caution when
loading and unloading bases.
11. The charger requires ample air flow to cool the
internal electronic components. Air is pulled in
from the bottom of the unit from the front and
sides, and exhausted towards the rear of the unit.
Assure that nothing obstructs the airflow about all
four sides of the unit. Allow at least two inches
from a wall or partition.
A
! ATTENTION: Do not attempt to open the charger
or perform service of any kind. This product can only
be serviced by a Dinex
an
designated Dinex
888-673-4639 for service information.
! IMPORTANT: Any installation not matching the
requirements
automatically void the product's warranty.
! IMPORTANT: Every installation site has different
electrical
wiring
different local codes exist, it is the owner and
installer's responsibility to comply with all federal,
state, and local codes. Dinex
any consequential damages, either expressed or
implied, because of failure to comply with installation
requirements.
3
®
base and the charger
®
Authorized Service Agent or
®
personnel. Contact Dinex
discussed
in
this
manual
requirements.
Because
®
is not responsible for
Manual No. DURIII_2023A
®
at 1-
will
many
Advertisement
Table of Contents
