Introduction; Application & Use; Safety; Installation - CFS DINEX DuraTherm DX2011208 Operating And Maintenance Manual

Induction charger
Table of Contents

Advertisement

DuraTherm®

INTRODUCTION

Congratulations! You have purchased the new
®
®
Dinex
DuraTherm
Induction Charger. Your Dinex
®
DuraTherm
induction heated base system, when
used within a controlled hot food tray line process and
covered with Dinex
insulated domes, will keep hot
®
plated food between 60 to 90 minutes depending on
menu and initial temperature of food and plate.
Please read this manual for helpful guidelines on how
to use your new equipment. Should you have any
questions concerning the equipment, please call
®
Dinex
Service at 1-888-673-4639.
APPLICATION & USE
The equipment is for commercial use only. Not for
household use. It provides maximum induction
heating compatible with Dinex
®
®
Dinex
DuraTherm
and Smart▪Therm
and use only for the purpose described.

SAFETY

The instructions contained in this manual provide
important
guidelines
regarding correct and safe installation. As you read
this manual, particular attention should be paid to the
precautions given in various parts of this manual with
the following indicators.
! ATTENTION: Use of this symbol identifies a
potentially hazardous situation which, if not avoided,
may result in damage to the machine or injury to the
operator.
! CAUTION: If the product is used without observing
the information given under this symbol, minor
personal injury, or damage to equipment may result.
! IMPORTANT: Key information for use and
maintenance of the equipment.
®
2023 CFS Brands- Dinex
| Oklahoma City, OK 73131
www.cfsbrands.com
| 800.654.8210
®
bases. Use with
®
bases only
for
the
equipment
user
GENERAL SAFETY PRECAUTIONS:
! IMPORTANT: The following instructions reduce the
risk of fire, electric shock, injury, and damage to
®
equipment.
!
Do not attempt to repair this equipment.
Repairs and service work must be performed
by qualified service technicians. Service work
performed by anyone other than authorized
®
Dinex
service agents will void the warranty.
!
Do not allow water near the charger. Allowing
water near the charger may cause a fire or
electric shock.
!
Do not ever put a base in the microwave. A
microwave will damage the base.
!
Do not stack the bases on the charger,
charge ONLY one base at a time.
!
Do not use damaged bases.
!
Do not leave bases unattended on the
charger.
!
Do not attempt to heat anything other than a
®
Dinex
base. Use of other than genuine
®
Dinex
bases and/or replacement parts will
void the warranty.
!
Do not use the equipment as a work surface
or cutting board.
!
Do not use corrosive cleaners on the
equipment. Use only mild detergents.

INSTALLATION

SET UP
1. Carefully remove any packing material from the
induction charger and check loose packing
material for small parts or accessories. Inspect
the charger for concealed damage before placing
packing material aside. Keep the packaging until
you
are
confident
performance.
2. The DuraTherm
top of a flat, level countertop or shelving. Be
careful to maintain at least two inches of
2
with
the
equipment's
®
Charger must be installed on
Manual No. DURIII_2023A

Advertisement

Table of Contents
loading

Table of Contents