Leg Support; Mounting The Rear Lashing Fitting, Fixed Armrest; Resizing Of Hole In Fitting For Electric Leg Support; Screwing On The Fitting - Vela Blues 100 Mounting Instructions

2.1. LEG SUPPORT

M8x20 Allen
screws 30 NM
Mounting the edge covering
Lift the top of the armrest and push the edge covering
down over the part attached to the chair and then repla-
ce the upper part. This is done on both sides. The purpo-
se of the edge covering is to prevent sharp edges cutting
through the seatbelt in the event of sudden braking or a
collision.
2.0.4. MOUNTING THE REAR LASHING FITTING, FIXED
ARMREST
First, fit the block with 8 threaded holes into the C-rail,
then firmly tighten 2 x pinol screws (11 NM), one in the
threaded hole behind the armrest and the other at own
option. Then mount the seat back hinge with washers
and two M8x16 screws (30 NM). The plastic covering is
attached to the fitting with a small screw from behind.
2.1.1. RESIZING OF HOLE IN FITTING FOR ELECTRIC LEG
SUPPORT
The hole indicated must be enlarged to Ø8 for the las-
hing fitting to be screwed to the chair if it has an electric
leg support.

2.1.2. SCREWING ON THE FITTING

First, the threaded block must be fastenedinto the C-rail
with 2 x pinol screws (11 NM), after which the fitting is
screwed on (30 NM) together with the lashing fitting,
using 2 x M8x20 Allen screws with low profile heads,
without washers.
7