Mounting The Lashing Kit; Mounting The Lashing Fitting, Front; Mounting The Tubular Leg On C-Rails; Mounting The Rear Securing Fitting, Folding Armrest - Vela Blues 100 Mounting Instructions

2.0. MOUNTING THE LASHING KIT

6

2.0.1. MOUNTING THE LASHING FITTING, FRONT

First, fit the block with four threaded holes in C-rail and 2
x screws are firmly tightened (11 NM) into the two middle
threaded holes. Then mount the securing fitting with
washers and two M8x16 screws (30 NM).
Note that the hook label must face the rear.

2.0.2. MOUNTING THE TUBULAR LEG ON C-RAILS

A tubular leg is fitted at both ends of the C-rail on both
sides. The tubular leg must cover the sharp edges of the
C-profile in the event of the seatbelt slipping this far back
on sudden application of the brakes. The opening in the
side of the tubular leg faces inwards towards the seat.
2.0.3. MOUNTING THE REAR SECURING FITTING, FOLDING
ARMREST
First, fit the block with 8 threaded holes into the C-rail
and firmly tighten the 2 x pinol screws (11 NM), one of
them into the threaded hole hidden behind the armrest
and the other at own option. Then mount the lashing
fitting to the two holes in the bottom of the armrest with
washers and two M8x20 skruer screws (30 NM).
2.0.3.1. MOUNTING THE REAR SECURING FITTING,
FOLDING ARMREST (VELA BLUES 210)
First, fit the block with 8 threaded holes into the C-rail
and firmly tighten the 2 x pinol screws (11 NM), one of
them into the first threaded hole and one in the second.
The first hole is used to fit the backrest angulation in.
Then mount the lashing fitting to the two holes in the
bottom of the armrest with washers and two M8x20
skruer screws (30 NM).