Toshiba Carrier TCB-IFDMR01UP-UL Service Manual page 50

NOTE
The following changes are settings to be configured by installation and service personnel.
If they are set incorrectly, trouble such as the product becoming inoperable may occur.
Set the following DN code according to the Ton of the Dx-coil interface and the model name of the Valve kit.
1. . Dx-coil interfac Ton
Dx-coil capacity
Capacity code (DN11)
Dx-coil capacity
Capacity code (DN11)
Dx-coil capacity
Capacity code (DN11)
Dx-coil capacity
Capacity code (DN11)
2. . alve kit type name specification (This is basically set automatically).
Valve kit model
Code (DN) 4AE
Notice code signal setting (Terminal DI4 / DI4: Notice code Input)
Notice code is a function dedicated to TU2C-Link communication.
[Function]
• Enter the Notice code when you want to report an abnormality that does not stop the air conditioner from the outside
• Used by switching functions with settings of Code No. (DN Code).
• Notice code is continuously issued while input signal is ON
• 201 is displayed in the Notice code history when there is input in DI4
[Setup method]
* Set data corresponding to Notice code to be used to one of Code No. 180 to 189, in accordance with following table
In case where data other than 0000 is already set, set to other Code No. (DN Code).
Code No. (DN) Set data
0180 ~ 189
* 1: Refer to the Service Manual for support
* It may take up to ten minutes to be displayed on remote controller after Notice code is issued
0.6 Ton 0.75 Ton
0001 0003
2.5 Ton 3 Ton
0013 0015
6 Ton 8 Ton
0021 0023
20 Ton 24 Ton
0031
0035
RBM-A0601UPVA-UL
0003
Notice code display
0000 None (Factory default)
0129 201 (DI4 / DI4 Notice input ON)
0134 206 (Tx sensor*¹ trouble)
1 Ton 1.25 Ton 1.5 Ton
0005 0007
4 Ton 4.5 Ton
0017 0018
10 Ton 12 Ton 14 Ton
0024 0026
28 Ton 32 Ton
0037 0039
RBM-A1201UPVA-UL
0001
- 50 -
2 Ton 2.25 Ton
0009 0011 0012
5 Ton
0019
16 Ton
0027 0028
RBM-A1921UPVA-UL
0002