Wolf CT15E/S Use & Care Information Manual page 15

W O L F E L E C T R I C C O O K TO P
C O O K TO P O P E R A T I O N
T R I P L E - Z O N E E L E M E N T
To turn on a triple-zone heating element,
touch the OFF ON touch pad of the control
that corresponds with the triple-zone element.
Refer to the illustration below.
Set the heat setting for the inner element
zone as described on page 14.
Touch ZONE 2 and the middle element
zone will be turned on to the same heat
setting as the inner zone. A light will remain
on under the ZONE 2 touch pad to indicate
the middle element zone is on.
Touch ZONE 3 and the outer element zone
will be turned on to the same heat setting
as the inner and middle element zones.
A light will remain on under the ZONE 3
touch pad to indicate the outer element
zone is on.
Changing the heat setting to the entire
triple-zone element is the same as for a
single element.
If ZONE 3 is turned on directly, ZONE 2 will
automatically be turned on. Similarly, if all
three zones are turned on, turning off ZONE 2
will automatically turn off ZONE 3.
When ZONE 3 is turned on, lights under the
other two zones will dim. This is normal.
Dual-zone
element control
Dual-zone element
Dimensions in parentheses are in
millimeters unless otherwise specified.
U S E & C A R E
B R I D G E - Z O N E E L E M E N T
When activated, the bridge-zone element
creates an oblong heating area for use with a
griddle, open roaster or fish poacher.
To turn on the bridge-zone heating element,
touch the OFF ON touch pad of either control
that corresponds with the bridge zone element.
Refer to illustration below.
Set the heat setting for either the front or
rear element as described on page 14.
Touch BRIDGE. The bridge element and the
element that is not turned on will both be
set to the same heat setting as the first
element. Lights will remain on under the
front, rear and bridge element touch pads
to indicate the bridge-zone elements are on.
Changing the heat setting of the entire
bridge-zone element is done the same as
for a single element. All three elements
maintain the same heat setting.
Touch BRIDGE again to turn off the bridge
element. The light under the bridge element
touch pad will go out. The front and rear
elements will remain at the current heat
setting and will become independent of one
another.
The illustrations below show the control panel
of Model CT36E.
Triple-zone
element control
Triple-zone element
Bridge-zone
element control
Bridge-zone element
15