Wolf CT15E/S Use & Care Information Manual page 14

W O L F
C O O K TO P
S I N G L E E L E M E N T A N D I N N E R Z O N E
To turn on a heating element, touch the
OFF ON touch pad that corresponds to the
element you wish to use. The power bar
indicator graph will begin to blink and show
a half-power status.
Touch one of the following symbols or touch
pads of the element control while the power
bar indicator graph is still blinking:
Touch HIGH to set the element at the
highest heat setting.
Touch the "+" or "–" symbol to set the heat
setting at half-power output.
Touch SIM or MELT to set the element at
the lowest heat setting.
To change the heat setting:
Touch the "+" or "–" symbol to change the
heat setting incrementally up or down.
Touch HIGH to set the element at the
highest heat setting.
Touch SIM or MELT to set the element at
the lowest heat setting.
Touch OFF ON to turn the element off.
IMPORTANT NOTE: To quickly turn off all
heating elements, use the universal OFF touch
pad located in the lower right area of the
control panel. Refer to the illustration below.
Heating element activation
14
E L E C T R I C C O O K TO P
O P E R AT I O N
"+" and "–"
symbols
OFF ON
touch pad
Heat settings
U S E & C A R E
D U A L - Z O N E E L E M E N T
To turn on a dual-zone heating element,
touch the OFF ON touch pad of the control
that corresponds with the dual-zone element.
Refer to the illustration on the following page.
Set the heat setting for the inner element
zone as described previously.
Touch ZONE 2 and the outer element zone
will be set to the same heat setting as the
inner zone. A light will remain on under the
ZONE 2 touch pad to indicate the outer
element zone has been turned on.
Changing the heat setting to the entire
dual-zone element is the same as for a
single element.
Touch ZONE 2 again to turn off the outer
element zone. The light under the ZONE 2
touch pad will go out.
The illustrations below show the control panel
of Model CT36E.
HIGH
touch pad
SIM touch
pad
Universal OFF touch pad
Universal OFF
touch pad