Page 2
RTI NEO SERIES USER‘S MANUAL Edited: 2023-07 Legal Notice LaserAnimation Sollinger GmbH reserves the right to make changes to its products for the purpose of technical improvement. These changes are not necessarily documented in each specific case. This document and the information contained herein have been prepared with the utmost care. No responsibility can be taken for the unlikely case of printing or other errors and any resulting damage.
RTI NEO SERIES USER‘S MANUAL Edited: 2023-07 1 Contents of Package Please make sure that all components were delivered correctly. Please also compare the separately supplied packing list If something is missing, please contact your sales contact. Name Picture Laser projector...
RTI NEO SERIES USER‘S MANUAL Edited: 2023-07 2 Safety Hints 2.1 General Hints The laser projector is intended only for proper use for projecting laser beams onto a projection surface (walls, screens) or into space indoors or outdoors. The device may not be used when there is visible damage to the housing, the connectors in the rear, especially the electric power supply, or the connecting cables.
Page 6
RTI NEO SERIES USER‘S MANUAL Edited: 2023-07 Allow the device to acclimatize sufficiently at the place of use. Do not operate the device if the dew point is > 18°C, as condensation can occur on the cooler components. Do not switch the device off between operating times, simply activate interlock / E-stop to disable laser emission.
RTI NEO SERIES USER‘S MANUAL Edited: 2023-07 2.2 Hints for Laser Safety Caution – use of controls, adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. This laser product is designated as Class 4 during all procedures of operation, maintenance and service .
Page 8
RTI NEO SERIES USER‘S MANUAL Edited: 2023-07 • Never let the laser run unattended. • Make sure that no unauthorized persons have access to your laser system. The operation of laser equipment in the event sector with an audience requires an approval...
Page 9
RTI NEO SERIES USER‘S MANUAL Edited: 2023-07 1. Laser radiation! Avoid exposure to beam 2. Laser class 4 3. Caution of radiation if cover is removed 4. Model type 5. Production year 6. Output power 7. Wavelength 8. Power supply & consumption LaserAnimation Sollinger GmbH | Crellestr.
RTI NEO SERIES USER‘S MANUAL Edited: 2023-07 3 Device Connectors 3.1 Overview All included signal cables are shielded . In case you use other cables (e .g . for remote control, Interlock, external key switch) it is essential to use shielded cables only.
Connect ‚DMX in‘ via a DMX cable to a DMX controller. ‚DMX out‘ is intended to Daisy Chain the control signal to the ‚DMX in‘ interface of a further RTI NEO device.
RTI NEO SERIES USER‘S MANUAL Edited: 2023-07 4.3 Interlock (RJ45 Interlock) Interlock in There are a ‚Interlock in‘ and a ‚Interlock out‘ (Interlock loop) interface on the rear side of the device. The RJ45 interlock bridge is provided for testing purposes. During normal operation, a dedicated E-Stop with key switch has to be used.
Page 14
RTI NEO SERIES USER‘S MANUAL Edited: 2023-07 By switching on the device for the very first time, DMX:1 appears on the display: Press the down button (arrow down) and change the DMX address by using the + /- buttons: By pressing the down button (arrow down) again the mode can be changed by using the + / - buttons.
Page 15
RTI NEO SERIES USER‘S MANUAL Edited: 2023-07 Beam Block Panel The Beam Block Panel is meant as additional protection to prevent laser emission, e.g. into the audi- tion area. To prevent laser emission please loosen the screws and slide the panel in front of the beam outlets.
RTI NEO SERIES USER‘S MANUAL Edited: 2023-07 Final statement All our products and their packaging are individually checked and leave our facilities in a flawless and proper condition. If you notice any damage or defects when receiving the product, please contact your dealer immediately.
EU Declaration of Conformity Manufacturer: LaserAnimation Sollinger GmbH Product Name: RTI NEO 6 RTI NEO 12 Products covered by this declaration: Laser display systems We here declare that the product described above is in conformity with the following directives: — 2014/35/EU Low Voltage Directive —...
Need help?
Do you have a question about the NEO Series and is the answer not in the manual?
Questions and answers