Removing The Container; Filter Mantainance; Floor Brush; Storage - G3 Ferrari ECO DESIGN G90003 User Manual

REMOVING THE CONTAINER

The dust bin (4) must be emptied when full of dust. In any case empty it frequently, in order to ensure good
performance of the vacuum cleaner and to prevent any leak in the air flow power.
To empty the bin, follow the instructions below:
- Grasp the handle of the dust bin (4) and press the release button of the container (A); remove the dust bin
from the unit by pulling it out.
- Bring the dust container (4) over a bin and press the release button (C) which is located on the back of the
container. This button will open the door dropping all the dirt. It is recommended to do this outdoors to
avoid soiling the house when the dust comes out of the trash.
- Lightly beat the dust container to bring down the last remnants.
- Close the door. Install the dust bin (4) on the main unit by matching the openings for air circulation by
pushing it until you hear a click.
FILTER MAINTENANCE
DISASSEMBLING THE FILTER SYSTEM
Once extracted dust container (4), to disassemble the filter (F) from the dust bin (4), follow the steps below:
- Grasp the handle (5) of the container (4) and turn the cover lid anticlockwise.
- Remove the filter assembly from the dust container (4).
- Lift the blocking clip of the lid (B) and open the lid.
- Clean the filter that is under the lid as described in the next paragraph.
- At the end of the cleaning process, re-assemble as follows
o insert the filter.
o Attach the lid to the bin (4) by turning clockwise.
- Install the container (4) on the main body of the unit.
The air-outlet filter is placed in the rear of the unit, at the right of the resting hook (6). To remove it, follow
the steps below:
- Remove the grid by pulling the tab and remove the filter inside.
- Clean the filter as shown in the next section.
- During installation make sure to properly assemble the filter and the grid.
CLEANING FILTERS
The filters can be cleaned in various ways. For a brief cleaning lightly beat them on a trash can.
For a more thorough cleaning using compressed air or rinse with warm water. In this case, DRY THEM
THOROUGHLY.
Caution: Do not use detergent to clean the filters, the cyclone or the container. The filters must be completely
dry before being assembled again.

FLOOR BRUSH

The floor brush can be adjusted in two ways, depending on the type of floor to clean. The position are:
a) For carpets

STORAGE

Rewind the power cord by using the button (2) and place the floor brush into the proper
resting hook (6) placed on the back of the unit.

MAINTENANCE AND CLEANING

MAINTENANCE
Normally this vacuum cleaner is not very noisy. But when the dust bin is full the noise emitted changes and
the suction power decreases. To lengthen the life of the product, it is recommended to empty the dust bin
frequently.
Even the filters, as mentioned previously, should be cleaned periodically. These filters can also be damaged
or depleted; in these cases they should be replaced with original new ones.
CLEANING
CAUTION: Before attempting any cleaning operation, ensure that the unit is turned off and the power
b) For floors
12