Advertisement
BM-H2000PN
Adjustment
Item
Test equipment | Test points
locations
Adjustment procedure
9. Repeat steps 7 and 8.
10. Supply an ail green signal input and shift the
deflection yoke forward to where he overall
screen is a green single color.
11. Also check the red and blue single color
tasters.
12. Svitably tighten the deflection yoke securing
screw to prevent forward to rearward shifting,
Static
Signal
Deflection yoke —{ 1. Supply a crosshatch pattern input.
(center)
generator(crosshat
Wedges
2.
Move the defiection yoke up, down, left and
convergence | ch)
Gonvergonte
right to roughly adjust the perimeter
adjustment
convergence. Temporarily secure with one
magnets
wedge at the top.
Rear
Deflection yoke
(Fig.5)
3.
Use the 4 pole magnets to overlap red and
biue at the picture center to produce magenta.
4.
Use the 6 pole magnets to overlap the green
lines with the magenta.
5.
If required, repeat steps 1 and 2.
Open 2 tabs
Turn together
while holding
the angle
between tabs
(Fig.6)
44 (No.51042)
Advertisement
