Table of Contents
Advertisement
4
Getting started
1. Configuring the antenna
Connect the accessory antenna to the GNSS ANT of TB-1 unit.
Locate the antenna in an open sky condition. (Refer to Chapter 8. GNSS Antenna Installation)
2. Connecting to the power
Connect the included USB cable (TypeC connector) to the Power USB jack of TB-1, and TypeA
connector to a USB power adapter.
※Power supply: DC5V 2A
※Power LED will illuminate.
3. Wait until Lock LED illuminates green.
In about 5 minutes after power-on, Lock LED(green) will illuminate and 10MHz & 1PPS becomes
available to connect with the corresponding devices.
Connect 10MHz and 1PPS to sync
corresponding devices
5
TB-1
Operation Manual
SE20-900-014-02
Advertisement
Table of Contents
