Advertisement
18
at-lerelgellale|
numeric buttons
Make sure that TIMER is set to OFF, and turn on the power.
Insert a cassette and press & to load the cassette(See page 16).
Then locate the position at which you want to start recording.
To start recording from the beginning of the tape, press <#@. (7 9 P will
appear at the beginning of the tape.)
To start from the middle of the tape, locate the point immediately before
the blank section. (See page 22.)
If recording has been applied to the entire tape and there is no blank
section, locate the desired point by playing it back.
Set INPUT to ANALOG, OPTICAL or COAXIAL depending upon your
sound source.
Press REC.
REC
| , ® and I indicators lights, and the deck enters the record-pause
mode. The sampling frequency to be applied for recording appears.
If the digital copy prohibit signal is written on the codes of the
sound source, '"PROH" appears in the display window and signifies
that you cannot record that source with the digital-to-digital
connection. In this case, use the analog-to-analog connection.
When recording the analog input signal, adjust the recording level.
(See page 20.)
No recording level adjustment is required when recording the digital input
signal.
Advertisement
