Advertisement
4.1.
Use screw 13 to install the wheel 17 onto the foot base 14 and tighten the screw (fig.2).
4.2.
Install the assembled foot base 14 onto the cylinder 1 with the screws 15. When all four wheels are on the ground , lock the screws in
turn and cover the hole plug 16 (fig.3).
4.3.
Install the X-axis bracket assembly 5 onto the Y axsis bracket assembly 4 and fix them with plug screws x3 and screw nuts 12. Then
install, and lock the set screws 8 as shown in fig.3
4.4.
Install as shown in fig.4 fit the instaled Y-axis bracket assembly 4 onto the panel 9 and fix them with set screws 2 and screw nuts 12.
4.5.
Fix the support strip 7 on the panel assembly 9 with round head square neck bolts 6, flat washers 10 and wing nuts 11, place the
assembled bracket on the oil cylinder 1 as shown in fig.5. Then pull out the exhaust rod, press down on the foot pedal B and remove
the pin.
NOTE: The exhaust rod cannot completly come out of the rubber plug.
© Jack Sealey Limited
fig.2
fig.4
Original Language Version
fig.3
fig.5
fig.6
500TTJ.V3, 800TTJ.V2
Issue 1 02/10/23
Advertisement
