Advertisement
GETTING
STARTED
POWER
[]
Make sure that the TV/CATV switch is set to TV. Switch to CATV only if you plan to operate a cable box.
[]
Press the POWERbutton on the remote control or the TV front panel. The On Timer lamp will glow red.
[]
The first time you turn on the TV, the "Plug In Menu" will appear.
You should
turn to page 15 now
to learn more about this menu.
[]
To turn the power
off, press the POWER button again. The On Timer lamp will go out.
[]
The On Timer lamp remains
on while the On/Off Timer function
is active.
ADJUSTING
VOLUME
Press the VOLUME button on the front panel or remote control.
The volume
slidebar
will appear.
Press the MUTING button to instantly
turn the volume off. To restore the volume
to the
previous
level, press the MUTING button again.
CHANGING
CHANNELS
_1
10 key direct access.
Press the numbers
on the remote's
10 key pad. For single-digit
channel
numbers
press 0 then the
number.
For channels
above
100, press the 100+ button
plus the 2-digit
number.
E_
CHANNEL-/+
button.
Press the CHANNEL -/+ button,
it will scan the channels
in order,
[]
NOTE; After you operate the Auto Tuner Setup (page 75), all of the blank, or empty, channels
will be
removed
from scanning
so that there/s
no noise or channel snow when you scan, only active channels.
Return.
Press and release
the RETURN+ button to return to the previous
channel.
First, select a channel
(game #1). Then, select another
channel
(game
#2) with the 10 key pad and push the RETURN+
button to flip directly
back and forth.
LL"IJReturn+.
Press and hold down the RETURN+ button for three seconds.
The message,
"RETURN
CHANNEL
PROGRAMMED
!" will appear
and .you can scan as .you wish.
Press RETURN+ again and .you will go
back to the Return+
channel.
To cancel
a Return+
channel,
press and hold down the RETURN+ button for another
three seconds
and the message,
"RETURN
CHANNEL
CANCELLED
!" appears.
[] Pressing
a number
key or turning
the set off will also cancel
a Return+
channel.
Advertisement
