Clas Ohlson TBC30SXPDK1 Instructions

LED spotlight with wall mount
Art.no 36-9235 Model TBC30SXPDK1
Please read the entire instruction manual before use and
then save it for future reference. We reserve the right for any
errors in text or images and any necessary changes made
to technical data. In the event of technical problems or other
queries, please contact our Customer Services.
Safety
• This product is extremely bright. Do not look directly into
the light, doing so could cause eye damage.
• Never let children play with the product.
• The product must only be connected to a power supply of
230 V with a protective earth.
• The product must not be used in rooms where explosive
gases or liquids are used or stored.
• Treat the product with care and do not subject it to shocks
or impacts.
• Never immerse the product in water or other liquid.
• The product must not be covered.
• Never try to open the housing, repair or modify
the product in any way.
• Never use the product if your hands are moist or wet.
• Never use the product if it, its mains lead or plug is
damaged in any way.
• The light source of this luminaire is notreplaceable; when
the light source reachesits end of life the whole luminaire
shall bereplaced.
Installation
• Fasten the floodlight to a firm, level surface.
• Do not mount the floodlight where there is a risk of it
falling into water or other liquids.
Warning
• Make sure that the wall has no concealed electrical wiring,
gas or water pipes before drilling/screwing.
• Make sure that the power supply to the floodlight is
switched off/isolated.
• The floodlight should be connected to a power supply
protected by a safety device such as a residual current
circuit breaker/residual current device (RCCB/RCD).
1. Use the wall bracket
as a template and
mark out where
the screw holes are to
be drilled.
Note: You don't need to detach the wall bracket from
the floodlight, it pivots to make it easier to mark out holes
for drilling and screwing in mounting screws.
2. Use an appropriate type of screw for the wall material and
attach the bracket to the wall.
3. The floodlight has 80 cm mains connection cable.
4. Tilt the floodlight
to the desired
angle and tighten
the screws fastening
the wall bracket to
the floodlight.
Instructions for use
1. Connect the mains lead to a 230 V power point.
2. Unplug the work light after use.
Care and maintenance
Unplug it from the electrical outlet. Clean the exterior of the
light by wiping it with a damp cloth. Use only mild cleaning
agents, never solvents or corrosive chemicals.
Note: The light source of this luminaire is notreplaceable;
when the light source reachesits end of life the whole
luminaire shall bereplaced.
Responsible disposal
This symbol indicates that this product should not
be disposed of with general household waste.
This applies throughout the entire EU. In order to
prevent any harm to the environment or health hazards
caused by incorrect waste disposal, the product must
be handed in for recycling so that the material can be
disposed of in a responsible manner. When recycling
the product, take it to your local collection facility or
contact the place of purchase. They will ensure that
the product is disposed of in an environmentally sound
manner.
Specifications
220–240 V AC, 50/60 Hz
Rated voltage
Power 30 W
Colour Black
Light source 2400 lm (non-replaceable)
Colour temperature 4000 K
Colour rendition > 80 Ra
Beam angle 120°
IP rating IP65
Class 1 (the product must be earthed)
Protection class
Operating temperature −20 to 40 °C
Connecting cable 80 cm, H05RN-F3G1.0 mm²
Size 184 × 165 × 53 mm
English