Operating Range; Watching 3D Video - Samsung UE46F8500A Manual

• Operating range

Recommended pairing distance
2~6m
Recommended viewing distance
Recommended viewing distance
Recommended pairing distance
Once the 3D glasses are paired, the remaining
✎
battery capacity is displayed on the TV screen. (This
feature only applies to Samsung F series 3D TVs
and 3D glasses that have been available since 2013.)
If you keep trying to pair the glasses and the TV, the
✎
battery level will decrease significantly. However, the
battery level will recover to a certain degree in about
a minute.
The working distance depends on the existence
✎
of obstacles (a person, metal, walls, etc.) between
the glasses and the TV and the strength of the
Bluetooth signal.
Turn off the 3D glasses while they are not in use.
✎
If you leave the 3D glasses on, the battery lifespan
decreases.
50 cm
2~6m (6.5 to 19.5 ft)
50 cm or less (19.5 in)
English - 16
Pairing steps
1. Turn on the TV, and then move the glasses within
19.5 inches of the TV.
2. Press the power button on the 3D glasses briefly.
The 3D glasses will power on and pairing will start.
3. The message "3D glasses are connected to TV." will
be displayed on the TV screen when the pairing is
successfully completed.
• If pairing fails, the 3D glasses will power off.
• If the first attempt to pair fails, power the TV off
and on again and perform step 2.
• How to pair again: Press the power button on
the 3D glasses for more than 1 second.
Pairing is needed again in the following
situations:
• If the 3D glasses do not function, even when the
power button is pressed, especially with a 3D TV
after a repair.
• If you want to play 3D content on another
Samsung 3D TV model that belongs to the D, E,
or F series released in 2011 through 2013. You
must pair the glasses with the other TV.

Watching 3D Video

Some 3D modes may not be available depending on the
format of the image source.
To watch in 3D, you must wear 3D Active Glasses and
turn the glasses on by pressing the power button.
1. Go to the 3D screen. (Picture > 3D)
2. Select the 3D Mode. The 3D Mode screen appears.
3. Set the 3D Mode of the image you want to view.