Interior Lights - Audi A8 2015 Owner's Manual

50 Clear
v is ion
&
WARNING
High beam assist is only intended to assist
the driver. The driver is still responsible for
controlling the headlights and sw itching
th e high beams on and off manually de-
pending on traffic, lighting and visibility
condi t ions. Failure to intervene manually
may lead to ris k of accident . It may be nec-
essary to operate the high beams man ua l-
ly in the following situat ions, e.g .:
- For adverse weather conditions such as
fog, heavy rain, blowing snow or spraying
water .
- On roads where oncoming traffic may be
partia lly obsc ured such as expressways .
- If there are individuals on t he road with
no light ing or poor lighting, such as cy-
clists .
- In tight curves and on steep s lopes .
- In poorly lit areas.
- With strong reflectors su ch as signs.
- If the area of the windshie ld nea r t he
sensor is fogged over, d irty, icy or cov-
ered with a st icker.
(D
Tips
- The high beam ass ist is active above a
speed of approx . 25 mph (40 km/h).
- If afte r activation, your speed falls below
approx . 15 mp h (24 km/h), the high
beams will automatically be switched
off.
Interior lights
Front and rear interior lighting
Fig. 44 Headliner: Front inter ior lights
Fig. 45 Rear headli ner: Reading light
Press the app ropriate button
~
fig. 44:
~ - Inter ior light ing on/off
l!l-
Door contact switch. The interior lighting
turns on automatically when you unlock the
vehicle, open a door or switch the ignition off.
The interior light ing turns off several seconds
after you close the doors, when you lock the
vehicle or when you switch the ignition on .
When a doo r is open, the light turns off after
a few min utes.
~ - Read ing lights on/off
~
- Switching the rear read ing lights on/off
from the cockpit .
I REAR MODEi* -
Switch ing the rear readi ng
lights on/off from the cockpit : press the
I REAR MODE !
button and then t he appropriate
button ~ in the cockpit.
Ambience lighting
Applies to veh icles: wit h amb ience lighting
You can select a color profile and br ightness
for the ambie nce lighting in various areas of
the vehicle, called zones.
Turning ambience lighting on
.. Select in the MMI:
ICAR !
function butto n >
Car systems
control button >
Vehicle set·
tings > Interior light ing > On.
Adjusting / turning off the brightness
• Sele ct in the MMI:
ICARI
function button >
Car systems
control button >
Vehicle set-
ting s> Inte rior light ing > Brightness.