Troubleshooting - ubbink Robotclean 3 PLUS Operating Manual And Parts List

1 Robotclean 3 PLUS Operating Manual and Parts List
Technical data
Article
Input voltage
Output voltage
Storage temperature
Working temperature
Transformer mains cable
Dimensions
Input voltage
Storage temperature
Working temperature
Max. immersion depth
Floating DC cable
Dimensions
Type of cleaning
Cleaning surface
Safety system (over-voltage protection)
Cleaning cycle
Filter unit
Suction power
Anti-winding system

Troubleshooting

Do not repair the pool cleaner yourself! If you use unsuitable parts for the repair, the risk of an electrical short circuit can increase greatly. Some problems may be caused by minor faults
that you can fix yourself. To do this, follow the instructions below according to the problem in question.
If this does not solve the problem, please contact the customer service department and keep the required information at hand according to the item "Ordering spare parts".
Fault
Error code 1H and 3H flash together
Cable twisted or winds up
Pool cleaner does not reach the entire pool area
Pool cleaner does not work
Pool cleaner does not climb the pool walls
Manual RobotClean 3 PLUS 2023 print.indd 4 Manual RobotClean 3 PLUS 2023 print.indd 4
7505520
Transformer
ROBOTCLEAN
Technical properties
Cause
Pool shape or circular cleaning pattern
Obstruction in the pool
Long working time
Transformer positioned incorrectly
Algae on the pool floor
Customised pool shape
Pool filter system is switched on
Cable in the pool not long enough
Power cable not connected properly
Blocked
Electrical fault
Filter baskets soiled
PVC wheels are worn
Climbing height
AC 100 - 230 V / 50 Hz, max. 120 W
DC 28 V, 4.5 A
10 °C - 40 °C
5 °C - 45 °C
2.0 m
280 x 220 x 80 mm
DC 28 V, max. 100 W
10 °C - 40 °C
10 °C - 35 °C
2 m
15 m
210 x 435 x 415 mm
Floor, walls, waterline
max. 130 m²
Yes
1 / 2 / 3 h
100 Microns
16 m³/ h
Yes
Solution
Stop the pool cleaner, check whether there is a blockage in
the brush system or rotor
Untangle the cable
Remove the obstruction in the pool
Untangle the cable
Place the transformer in the correct position so that the
cleaner can reach the entire area
Remove algae from the bottom and walls of the pool
Place the cleaner in the position that needs special cleaning
Switch the pool filter system off
Release as much cable as possible into the pool
Check the power supply and the cable connections
Check the impeller or drive system
Contact your salesperson
Clean the filter baskets
Contact customer service to replace the PVC wheels
Fix float blocks to the cleaner
06.12.23 11:48 06.12.23 11:48