Setting Up The Remote; Controlling Tvs With The Remote - Sony RDR-GX7 Operating Instructions Manual

To check the channel settings
When displaying the "get VCR Plus+ Channels" menu, press
_/![' to select "Channel List," then press ENTER.
The display lists the channels whose guide channel number is not
as same as the TV channel number.
Se _ngs - VCR Pius+ Channel List Page2
Guide 0H TVOH G_ide CH _/CH I.
2 21 45 18
4 32 _
6 9
10 121
11 13
25 36
28 2
To go to the next page, press 1_.
To return to the previous page, press '_.
You can control your TV with the supplied remote by adjusting
the remote control's signal.
If you connected the recorder to an AV amplifier (receiver), you
can also control the volume with the supplied remote.
• Depending on the connected unit, you may not be able to control your
TV or AV amplifier (receiver) wifla some or all of the buttons below.
• If you enter a new code number, the code number previously entered
will be erased.
• When you replace the batteries of the remote, the code number may be
resel to the default setting. Set the appropriate code number again.
Controlling TVs with the remote
Number buttons, ....
SET
TV/DVDswitch
...............
I/cb
........ CH+/-
..... VOL +/-
..... TV/VIDEO
..... WIDE MODE
[] Slide the TV/DVD switch to TV.
[] Hold down I/_.
[] Enter your TV's manufacturer code (see
"Code numbers of controllable TVs" below)
using the number buttons.
[] Release I/_.
When the TV/DVD switch is set to TV, the remote
performs the following:
I/_
Turns your TV on or off
VOL +/-
Adjusts the volume of your TV
CH +/- Selects the channel on your TV
WIDE MODE Switches to or from the wide mode of a
Sony wide-screen TV
TV/VIDEO Switches your TV's input source
Number buttons and Selects the channel on your TV
SET
26
Setting Up the Remote