Step 1: Unpacking; Step 2: Connecting The Antenna Cable - Sony RDR-GX7 Operating Instructions Manual

Check that you have the following items:
• Audio/video cord (pinplug x 3 _ pinplug x 3) (1)
• Power cord (1)
• Antenna cable (1)
• Remote commander (remote) (I)
• Size AA (R6) batteries (2)
Hookup 1: Antenna only (no cable TV),
or cable without cable box
Use this hookup if you are using a VHF/UHF antenna or separate
VHF and UHF antennas. Also use this hookup if you watch cable
channels without cable box. With this hookup, you can record
any non-scrambled channel by selecting the channel on the
recorder.
to_VHF/UHFIN
DVD recorder
Select one of the following antenna hookups that best suits you
below. Do not connect the power cord until you reach "Step 5:
Connecting the Power Cord" (page 22).
Antenna only (no cable TV), or cable Hookup 1
without cable box (page 16)
Cable box with many scrambled channel_ Hookup 2
(page 17)
Cable box with a few scrambled channel_ Hookup 3
(page 17)
Note to CATV system installer (in USA)
This reminder is provided to call the CATV system installer's
attention to Article 820- 40 of the NEC that provides guidelines
for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.
TV
l to VHF/UHF OUT
[BC2_,,_toantenna input
Antenna cable (supplied)
I_,..'.'>_ : Signal flow
• If your antenna is a flal cable (3gO-ohm twin lead cable), use on
external antenna connector (not supplied) to connect the m_tenna to lhe
recorder.
• If you have separate cables for VHF and UHF antennas, _ase a UHF/
VHF band mixer (not supplied) to connect the antenna to the recorder.
16
Step 1: Unpacking