Advertisement
THANK YOU for choosing the N-audio Two Amps To
Cabinet switcher, and welcome to the N-audio family.
The Two Amps To Cabinet is an amp cabinet switcher with a
wide range of capabilities. Its primary functions involve
switching between two amplifiers to a single speaker cabinet or
one amplifier to two speaker cabinets. It features a
footcontroller and either one (Mono set) or two (Stereo set) relay
switching units.
One of the outstanding features of this device is its seamless
compatibility with any type of amplifier, including tube, solid-
state, and bridged mono amplifiers. It also includes built-in
protections, such as resistive loads for the non-working
amplifier, to ensure the safety of your amplifiers. The signal path
consists solely of relays, ensuring a pure tone with no active
electronics. A special circuit has been implemented to reduce
pops when switching, and there are no dead spots when
toggling between the amplifiers or the cabinets, making it
perfect for both stage performances and studio recording
sessions to capture your favorite guitar tones.
Footcontroller:
1. DC Input – Use an external DC BOSS-style center
negative power supply adapter (not provided). It powers
the footcontroller and the relay units.
2. MIDI In – Use it to remotely switch via MIDI from your MIDI
controller or multi-FX processor.
3. External control outputs – Use a mono guitar cable
between the footcontroller and relay box. It provides a
control voltage for the relay unit only. Both outputs are
identical, and you can control up to two relay units.
Introduction
Controls and connectors
Advertisement
