Advertisement
a
a
aN
ES
6) AKC Te
FM
RECEPTION
P
P
RIOR TO SWITCHING
OWER
ON
Before switching the power on, set the various controls as
fol
1.
2.
lows:
Set the two FILTER
buttons to the released
positions.
Press the SPEAKERS
button that corresponds
to the speaker system which is connected
to
the SPEAKERS terminals on the rear panel.
. Set the FM 25us button to the released posi-
tion.
. Set the FM
MUTING
button to the released
position (ON).
. Set the VOLUME
control to the © position.
. Set the BALANCE
control to the center posi-
tion.
. Set the MODE switch to STEREO.
. Set the TAPE MONITOR switches to the upper
positions (OFF).
. Set the DUPLICATE
switch to the upper posi-
tion
(OFF).
. Set the TONE switch to OFF.
. Set the MUTING
switch to the upper position
(OFF).
PROTECTION CIRCUIT
For some 6 to 10 seconds after the receiver is
switched ON, no sound will be heard. This is
due to the operation
of protection
circuits
which
are
designed
to safeguard
transistors
and
speakers
from
possible
damage
due
chiefly
to switching transients,
etc. Should
|
the
receiver
remain
silent
for
considerably
longer
than this, switch
off and check
the
Speaker
system
connections.
Should
the
receiver
suddenly
go
silent
while
you
are
listening
to it, and
a continuous
series of
"clicks"
can
be heard
from
relay contacts
opening and closing within the receiver, this
can be an indication of a short circuit in the
speaker system connections.
Switch off, and
re-check the speaker system impedances, etc.
The protection circuit re-sets itself automat-
ically, so that normal operation is resumed as
soon as the fault is corrected.
A
2.
3.
Depress the FM function button.
Slightly
turn the VOLUME
control
clockwise
direction to obtain the sound.
Select the broadcasting station with the tuning
knob.
Adjust so that the signal meter pointer
deflects as far to the right as possible and the
tuning meter
pointer is centered,
as indicated
in Fig. 10.
Press
the
FM
MUTING
button
if the signals
from the station are weak.
If the program is being broadcast in stereo, the
STEREO indicator will come on.
. Adjust the volume
with the VOLUME
control.
. To adjust the tone, first set the TONE switch to
ON, and then adjust the BASS
and TREBLE
controls for the preferred bass and treble levels.
Fig. 10
AM
RECEPTION
ray
. Depress the AM function button.
. Slightly
turn the VOLUME
control
clockwise
direction to obtain the sound.
. Turn
the tuning knob to select a station. The
best
reception
is obtained
when
the
signal
meter
pointer
deflects
to the extreme
right
(see Fig. 11).
4, Adjust the volume with the VOLUME
control.
5. To adjust the tone, first set the TONE switch to
ON,
and
then
adjust the BASS
and TREBLE
controls for the preferred bass and treble levels.
Fig. 11
NOTE:
If, when
listening to either an FM or AM broadcast, your
listening pleasure is seriously affected by poor sensitivity
or strong interference,
refer to the section
"ANTENNA
AND
GROUND
CONNECTIONS"
on page 8, and make
any necessary changes.
13
Advertisement
