Advertisement
[Continued next page |
ee
(ONC
CT.
TONE SWITCH
Set this switch
to ON
when adjusting the BASS and
TREBLE
controls.
In the OFF
position, it causes the
amplifier to operate with a flat frequency response.
rFUNCTION
BUTTONS
|
Ee
Press the function button which corresponds to the pro-
gram
source.
Turn
the
VOLUME
control
down
first
before selecting a different function
button while the
sound from one program source is being reproduced.
FM..........
Press this button for FM broadcasts.
The
FM
STEREO
indicator
lights
up when the receiver is tuned into an
FM
stereo
broadcast.
The sound
is
automatically received monophonical-
ly during FM monophonic broadcasts.
TREBLE
ee
TURNOVER
BASS AND TREBLE CONTROLS—
Use
these controls
to adjust the bass and the treble.
If you set the TONE
switch to ON and turn the BASS
control to the right from its center position, you will be
able to emphasize the sound in a frequency range which is
lower
than
that
selected
by the BASS
TURNOVER
switch. Conversely, turning this control from the center
position to the left will attenuate the sound.
You can use the TREBLE control to adjust the sound ina
frequency
higher than
that selected
by the TREBLE
TURNOVER
switch.
For
further
details,
refer
to
"TURNOVER
SWITCHES" on page 15.
BASS TURNOVER
SWITCH
Use this switch to change over the frequency at which the
sound adjustment with the BASS control is starting to
take
effect. Select 200Hz or 400Hz in accordance with
the
characteristics of your listening room
and of your
speakers, and with your general preference.
Press this button for AM
broadcasts.
Press this button when listening to an
audio
component
connected
to the
AUX input jacks.
Press
this
button
when
playing
a
record on the turntable connected to
the PHONO 2 jacks, or when using a
microphone
which
you
have plugged
into the MIC jack.
Press
this
button
when
playing
a
record on the turntable connected to
the PHONO 1 jacks.
PHONO 2/MIC..
PHONO 1
NOTES:
2.
Only
one
function
button
should
be pressed
at a
time.
MOME LOUDNESS
BALANCE
FB.
for
= 38
QPIONEER
STEREO RECEIVER
SX-SBO
TAPE
MONITOR
SWITCHES
(1, 2)
Set switch 1 to ON with a tape deck which is connected
to the TAPE 1 jacks (REC and PLAY) when you want to
monitor the playback or recording of a tape. The tape on
a deck which is connected to the TAPE 2 jacks (REC and
PLAY) can be similarly monitored by setting switch 2 to
ON. For further details, refer to "TAPE DECK OPERA-
TIONS" on page 16.
NOTE:
Set
these
switches
to the upper
(off) position when
listening to records or a broadcast.
L_TREBLE TURNOVER
SWITCH
Use this switch to change over the frequency at which the
sound adjustment with the TREBLE control is starting to
take effect. Select 2.5kHz or 5kHz in accordance with
the characteristics of your listening room
and of your
speakers, and with your general preference.
11
Advertisement
