Advertisement
vs.
TABLE
PAK INSTALLATION PROCEDURE
I.
Instruction Label
(See Illus. 1-4)
A.
Open table housing, remove
the four
(4)
nuts holding
the
plexiglass instruction label
cover, and remove
the
plexiglass
cover.
B.
Remove old instruction label carefully and save for
future use
C.
Remove paper backing strip on new label and install.
D.
Replace plexiglass
cover.
II.
Dip Switch Settings Instruction Label
A.
Remove paper backing on label and place on any unused
surface inside table housing.
(Remove old label
if
necessary.
Save for future use.)
III.
PPU ROM Kit
A.
Replace ROMs and PPUs
as
shown in
VS.
Game Operation
Manual
IV.
Factory Recommended Dip Switch Settings
A.
Check dip switch settings
on
P.C.
board
so
they match
the
factory recommended
dip
switch settings
sheet.
Advertisement
