LENCO HPB-830 User Manual page 8

The indicator light will be red while charging. Once fully charged, the indicator light will turn off. Charge time is two
hours on an empty battery.
The headset is with built-in lithium battery. Please charge at least 4 hours before first use.
(Suggestion: Don't use a car charger at first time).
Active Noise Cancelling On:
Short press the ANC button. You'll hear "ANC on". Green LED light will turn on.
NOTE: The ANC function can also be used without music. When answering the call, ANC function does not work
Active Noise Cancelling Off:
Short press the ANC button. You'll hear "ANC off". Green LED light will turn off.
Low Latency On:
Short press twice the ANC button. You'll hear "Low Latency on".
In this mode, Imperceptible delay for perfect lip sync and responsive gaming
Low Latency Off:
Short press twice the ANC button. You'll hear "Low Latency off"
Phone calls
To answer or end a call, when phone call comes, quickly press MFB to answer it or press and hold MFB about 1.5
seconds to reject the call.
Listen to Music
Connect the headset to phone or compatible Bluetooth devices that support A2DP Bluetooth profile. The available
music functions depend on your Bluetooth devices. If you receive or make a call while listening to music, the music is
paused until the call ends.
Disconnect the headset
To disconnect the headset from your device, switch off the headset, or disconnect the Bluetooth function in your
bluetooth device.
Reconnect the Headset
To reconnect the HPB-830 switch on by pressing the power button for 3 seconds, the HPB-830 will turn on and
automatically connects to the previously connected device. When connected successfully it will prompt "connected"
Reset to factory settings.
1. Go to the Bluetooth settings menu on your phone. Select the device listed as "HPB-830" and choose to
forget the device.
2. If your HPB-830 was turned on, the led light starts flashing blue/red. When It was off, turn the HPB-830 on.
The light will start blinking blue/red (pairing mode)
3. Press and hold the +/-buttons simultaneously for 10 seconds until you see the light flashes red 3 times, after
that the HPB-830 will turn off.
4. The factory reset is now completed.
8