Advertisement
STEP 5:
CHEMICALS
•
Dishwasher comes standard with built-in
adjustable detergent and rinse pumps.
•
On the back of the dishwasher, locate clear
tube marked "Detergent" and place inside
detergent container (Fig. 6).
•
The unmarked clear tube is to be placed inside
your rinse container (Fig. 6).
NOTE: Refer to the manual for detailed instructions
on pump adjustments.
NOTE: Use commercial-grade, high-temperature,
low-suds liquid detergent and liquid rinse.
FIG. 6
QUICK START GUIDE
STEP 6:
PREPARATION FOR USE
Open door and CUT tie wraps from the
•
wash and rinse arm. DO NOT PULL OFF.
•
Remove rack support, filter, and scrap
basket (Fig. 7).
•
Verify the overflow tube is placed and
secured with O-ring.
•
Place rack, filter, and scrap basket back into
the unit.
•
Turn on water and verify there are no leaks.
•
Turn on power.
•
The unit will begin to fill both the wash tank and
booster. Then, begin heating both tanks until the
wash tank is above 150°F and the booster
is above 180°F. Depending on your incoming
water, this may take up to 30 minutes to
achieve temperature.
FIG. 7
Run machine to verify that all electrical,
water, and drain hookups are correct,
chemical amounts are adequate, and
there are no leaks.
02/2024
Advertisement
