KitchenAid KFBP102LSS Installation Instructions And Use And Care Manual page 4

drain
poe 2 gemnemna
a washer
locknut
9 a Install the 1" (2.5 cm) drain fitting
in the ice bin and the 1-1/2" (3.8 cm)
drain fitting in the sink. Tighten securely.
Remove and discard the excess plumbers
putty.
1 0 a Ice bin drain and sink drain
fittings to be connected to drain system in
accordance with local code requirements.
apply clear
silicone
1 1 a Apply a bead of all weather
clear silicone on the under side of the
back and two sides of the top lip.
1 2 a Carefully position the Bar Cart
into the cut out. Immediately remove any
excess silicone.
plastic
hose
1 3 a Connect the plastic hose from
the waiter filter to the faucet connection
and tighten securely.
plastic
hose
inlet
connector
1 4 m Attach the plastic cold water
hose from the water inlet connection to
the inlet side of the filter. Use N.S.F. or
U.P.C.-listed water connection line for
water supply to inlet connector. Potable
water supply system to be connected to
inlet connector per local code
requirements.
1 5 a Unwrap the bottle rail and
bottle cap catch pan. Position them over
the key-lock studs and slide down to lock
in place.
1 6 a Unwrap the sliding cover and
place into frame on top of the ice bin.
Installation -
Portable model
FAUT:
Excessive Weight Hazard
Use two or more people to move
and install bar cart.
Failure to do so can result in back
or other injury.
Use a certified plumber to connect and
install potable water supply and drain
system to outdoor bar cart per local code
requirements.
1 aw Make sure you have adequate
drain connections for the Bar Cart.
2 a Remove the bottle rail, bottle cap
catch pan and waier filter from the ice bin.
3 a Remove the faucet from the sink.
4 a Install the faucet and fasten
securely.
plumbers putty
5 a Place a small amount of plumbers
putty around both the ice bin and sink
drain mounting seats.
drain
"~~ washer
N
6 w Ice bin drain and sink drain fittings
to be connected to drain system in
accordance with local code requirements.
locknut
t a Install the 1" (2.5 cm) drain fitting
in the ice bin and the 1-1/2" (3.8 cm)
drain fitting in the sink. Tighten securely.
Remove and discard the excess plumbers
putty.