Sony FD Trinitron WEGA KD-30XSR955 Operating Instructions Manual page 44

Setting Up the Channel List
After you finish connecting the TV, you need to run the k£tial Setup
feature, which automatically creates a list of available analog and
digital channels and lets you correct tilt and vertical correction
settings. The Initial Setup screens appear when you turn on your TV
for the first time after hooking it up.
Using Initial Setup
IL'II For more details on using
Tilt Correction and Vertkal
Correction, see pages 89-9£
_To exit the Tilt Correction
andVerticalCorrection screens,
presstbe MENUbutton.
_lf youare usinga
CabbCARD, A uto Programis
disabledfor the CABLE input,
Torun InitialSetup
1
Press POWER to turn on the TV.
The Initial Setup screen appears.
Using the remote control, move the highlight to the desired
lan_mage,o , then press _ to select that language. The Tilt
Correction screen appears.
2 Press _, ,_ to correct any tilt of the picture. You can choose a
correction between +7 and -7. When finished, press _.
3 _ The Vertical Correction screen appears. Press
_, to make a vertical correction to the picture. You can choose a
correction between +5 and -5. When finished, press _.
4 The next screen instructs you to connect your cable/antemm.
Check that you've connected your signal source correctly.
To start Auto Program, highlight Yesand then press _.
Auto Program automatically creates a list of receivable analog
and digital channels. Auto Program may take ,50minutes or more
to complete. A progress bar is displayed while the channel list is
being created.
When Auto Program is finished, the lowest numbered charmel is
displayed.
Torun Auto Programagain at a later time
[] Use the Auto Program feature as described on page 84.
Toadd individual digital channels
Use the Digital Channel feature as described on page 84.
Toreset the IV to
factory settings
1
Press POWER t o turn on the TV.
2 Hold down RESET on the remote control.
3 Press TVPOWER on the TV. (The TV will turn itself off, then back
ort.)
4
Release RESET.
43