Table of Contents
Advertisement
Remote control operation
@ Programming functions from other remote control units
1 @ Set the LEARN / USE switch to LEARN.
LEARN
USE
Mm |
é—
@ Set the mode switch according to the type of component functions to be programmed.
AUDIO
AUX
@ Usually, set the mode switch to AUX.
2 Place the transmitter section of this remote control unit so that it faces directly toward the
transmitter section of the other remote contro! unit.
,
6 i
Other remote
:
BL gO ena peo &
control unit.
da Sat 86 @ Ged
i4nGeagooogsa
Position the two remote control units so that their
transmitter sections are separated by a distance of 2~5
cm (13 / 16" ~ 2°).
3
Press the operation key you wish to program on this remote control unit.
Press one of the programmable learning keys.
Other remote
control unit
The LEARN indicator lights up.
4
Within 30 seconds after pressing the learning key, press the corresponding operation key of
the other remote control unit.
Transmitted.
@ Keep pressing the other remote control unit's operation key until the LEARN indicator goes out.
@ When the lighted LEARN indicator blinks twice and then goes out, programming is completed.
@ To continue programming other keys, repeat steps 3 and 4.
18 KR-V8050 (En)
Advertisement
Table of Contents
