Canon ADVANCED EOS IX 7 Instructions Manual page 65

Using the Built-In Flash
Set the Mode Dial to an Application
Zone mode.
Press the flash button.
+The flash unit pops up.
*To return the flash to its position,
press it back down into place.
Focus the shot.
Check the LCD panel.
Shoot the picture.
The image was removed due
to copyright restrictions
[i] fetta setings tor langer stance shots, ss page t,
* Shooting with the flash closer than 1 m (3 fi) can cause the flash to be obstructed in part of the
picture and make it appear dark. Always take flash shots at least 1 m (3 ft) from the subject.
* Using the builtin lash with the lens hood in place will block the light from the flash, Be sure to
remove the lens hood before using the built-in flash.
+ You cannot use the built-in flash and an external flash at the same time.
* Light from the built-in lash can be obstructed when used with the following lenses. If you need
to use a flash with any of these lenses, we recommend you use an EOS exclusive external
flash,
Large-diameter lenses such as the EF 17-35mm (2.8L USM, EF 28-70mm f/2.8L USL, etc.
Telephoto lenses such as the EF 300mm 12.81. USM, EF 600mm tl. USM, etc.
* The built-in flash has an angle of illumination that covers wide-angle shots up to a focal length
of 22mm. If you use a lens that has a focal length of less than 22mm, the edges of the resulting
picture will appear dark.
65 |