Echo DPE-2100 Operator's Manual page 29

Power edger
Table of Contents

Advertisement

DPE-2100
4.
Loosen adjustment knob (A).
Move wheel up to increase
cutting depth, or down to
decrease cutting depth. A depth
of 0.5 in. (13 mm) is optimal.
Tighten adjustment knob (A).
5.
Before edging, plan your
direction of travel so that the
unit will always be positioned
on your right side and so that
you walk on a hard surface
whenever possible.
6.
Position edger as shown.
Before edging, be sure to read and understand the entire
Operator's Manual to avoid serious injury.
7.
When starting to edge, run unit at top speed, and lower the blade gently
into the ground, being careful not to hit the concrete with the blade.
8.
Don't force the blade. Move only as quickly as the blade will allow.
X7508310301
© 12/23 ECHO Incorporated
OPERATION
A
A
13 mm (0.5 in.)
29

Advertisement

Table of Contents
loading

Table of Contents