Bosch Professional GAS 10 Original Instructions Manual page 10

10 | English
(25) Suction tube
(26) Snap fastener
(27) Intake port
(28) Clips for securing the plastic bag
(29) Filter holder
Technical data
Wet/dry dust extractor
Article number
Rated power input
Frequency
Container volume (gross)
Net volume (liquid)
Dust bag volume
A)
Max. vacuum
– Dust extractor
– Turbine
A)
Max. flow rate
– Dust extractor
– Turbine
Automatic start/stop
Weight according to EPTA-Proced-
ure 01:2014
Protection class
Protection rating
A) Measured using a vacuum hose 3 m long and 35 mm in diameter
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-specific models.
Values can vary depending on the product, scope of application and environmental conditions. To find out more, visit
www.bosch-professional.com/wac.
A)
Automatic start/stop
Rated voltage
TW 115 V
CN 220 V
High voltage 220–240 V
A) Permitted connected load of the connected power tool (country-specific)
Assembly
Pull the plug out of the socket before cleaning or per-
u
forming maintenance on the vacuum cleaner, making
tool adjustments, changing accessories or putting
away the vacuum cleaner. This safety measure prevents
the vacuum cleaner from being started accidentally.
Fitting the vacuuming accessories (see figure A)
The vacuum hose (16) is equipped with a clip system which
can be used to connect vacuuming accessories (dust extrac-
tion adapter (14), curved nozzle (17)).
1 609 92A 9DF | (26.01.2024)
(30) Filter basket
(31) False air intake
a)
(32) Blowing hose
a) Accessories shown or described are not included with the
product as standard. You can find the complete selection of
accessories in our accessories range.
GAS 10
3 601 JE5 0..
W 1100
Hz 50–60
l 10
l 8
l 8
kPa 22
kPa 27
l/s 33
l/s 53
–
kg 9.6
/ II
IPX4
Maximum power Minimum power
1050 W 100 W
1100 W 100 W
2200 W 100 W
Fitting the nozzles and tubes
– Push the curved nozzle (17) onto the vacuum hose (16)
until you hear both snap fasteners (26) on the vacuum
hose engage.
– Then attach the required extraction accessory (floor
nozzle, crevice nozzle, suction tube, etc.) firmly to the
curved nozzle (17).
– To remove the accessory, press the snap fasteners (26)
inwards and pull apart the components.
Fitting the dust extraction adapter
GAS 10 PS
GAS 10 PS
3 601 JE5 1..
1100
50–60
10
8
8
22
27
33
53
●
9.6
/I
IPX4
Bosch Power Tools