Table of Contents
Advertisement
Assembling
4.1
Safety notices for installation
Safety notices
When installing the device, keep to the safety notices listed below.
NOTICE
Improper mounting
Improper mounting may damage the device or impair its operation.
• Before mounting the device, always ensure that there is no visible damage to the device.
Note
The plug-in transceivers are only developed for a limited number of plug-in cycles.
• Pull and plug the plug-in transceiver only as often as required.
Safety notices on use in hazardous areas
General safety notices relating to protection against explosion
EXPLOSION HAZARD
Replacing components may impair suitability for Class 1, Division 2 or Zone 2.
When used in hazardous environments corresponding to Class I, Division 2 or Class I, Zone 2,
the device must be installed in a cabinet or a suitable enclosure.
Notes for use in hazardous locations according to ATEX, IECEx, UKEX and CCC Ex
If you use the device under ATEX, IECEx, UKEX or CCC Ex conditions you must also keep to
the following safety instructions in addition to the general safety instructions for protection
against explosion:
Transceiver SFP/SFP+/SCP/STP
Operating Instructions, 10/2023, A5E02630804-18
WARNING
WARNING
4
17
Advertisement
Table of Contents
