Solaira SMaRT 16-DV Installation & User Manual

Variable controller

Advertisement

Quick Links

Solaira SMaRT 16-DV Variable Controller
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
Serious injury or death could occur
Disconnect ALL power sources before removing cover. Power should only be re-connected after
electrical installations are complete and cover replaced
Be certain the power source conforms to specifications outlined on heater label
Maximum heater load SHOULD NOT EXCEED 16 AMPERE
Control MUST BE PROPERLY grounded. Assure to connect ground wire green wire from heater
to ground connection from electrical supply, not to a live or "hot" conductor.
Engineer/Electrician/Installer to determine suitability of this appliance in intended application and
compliance with all local, state/provincial and National electrical Code (NEC) requirements
Do not use locations containing hazardous or explosive atmospheres.
ELECTRICAL RATING
Maximum load
WARNING SERIOUS INJURY OR DEATH COULD OCCUR, DISCONNECT ALL POWER
PRIOR TO SERVICE
Due to ongoing product improvements, specifications and dimensions are subject to change without notice and without incurring obligations.
IOM ▪ SMaRT-16DV
Installation & User Manual
S
AFETY WARNING
ALL INSTALLATIONS/SERVICE MUST ONLY BE
PERFORMED BY A LICENSED/CERTIFIED ELECTRICIAN
TO LOCAL AND NATIONAL ELECTRICAL CODE (NEC).
WARNING: SHOCK AND FIRE HAZARD:
16A
SPE-1000 CANADA INSPECTED
@110-120V or 208-240VAC 50/60HZ
Rev 2. 11.19.22
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SMaRT 16-DV and is the answer not in the manual?

Questions and answers

Summary of Contents for Solaira SMaRT 16-DV

  • Page 1 Solaira SMaRT 16-DV Variable Controller Installation & User Manual KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE AFETY WARNING ALL INSTALLATIONS/SERVICE MUST ONLY BE PERFORMED BY A LICENSED/CERTIFIED ELECTRICIAN TO LOCAL AND NATIONAL ELECTRICAL CODE (NEC). WARNING: SHOCK AND FIRE HAZARD: •...
  • Page 2 INTRODUCTION The Solaira SMaRT 16-DV Control has a 1 to 5 step setting allowing you to find the optimum comfort setting in your specific area. To increase output to full output, press and release red button. To increase in increments, press and hold the red button until the desired number is reached.
  • Page 3 ONLY and may not be paired with SMaRT16-DV. FAILURE TO COMPNY MAY RESULT IN CONTROLLER DAMAGES. WARNING: Solaira SMaRT 16-DV Variable control is a high power electrical device and MUST ONLY BE INSTALLED BY A CERTIFIED ELECTRICIAN TO LOCAL AND NATIONAL ELECTRICAL CODE.
  • Page 4 DISPLAY FEATURES Display shows ‘t’ The unit is turned OFF as the ambient temperature is above the trip level set by TEMPERATURE SETPOINT. Display shows "0" The output is OFF Display shows "1", "2", The unit is ON at the indicated power level "3", "4"...
  • Page 5 Direction 45’ (18 Meters) Detection WARNING: Solaira SMaRT 16-DV Variable control is a high-power electrical device and MUST ONLY BE INSTALLED BY A CERTIFIED ELECTRICIAN TO LOCAL AND NATIONAL ELECTRICAL CODE Due to ongoing product improvements, specifications and dimensions are subject to change without notice and without incurring obligations.
  • Page 6 SMaRT 16-DV ILLUSTRATIVE WIRING DIAGRAM* *Connection diagram is for illustrative purpose only. Installation must be carried out by certified electrician to local, state/provincial and National Electric Code (NEC) requirements. Inforesight Consumer Products Inc. assumes no responsibility for the heaters or controller electrical plan or installation.
  • Page 7 Wire jumper installed for use WITHOUT optional Occupancy SENSOR (PIR) SMRTOCC PLEASE NOTE: If you are using a with the Solaira SMaRT 16DV and 34DV, the timer SMRTOCC function on the SMaRT Wall Switch SM-WSD will be overridden if the has been activated. SMRTOCC If you are not using a , the Link that is fitted as standard between the SIG IN / COM ‘MUST’...
  • Page 8 3. No charge for travel and/or mileage will be allowed to purchaser. 4. SOLAIRA reserves the right to make changes in design or make any improvements on any products. The right is always reserved to modify our equipment because of new technology, underwriter’s requirements and/or government regulations.

Table of Contents