Installation Instructions; Remove Mounting Plate; Rotate Blower Motor - Whirlpool MH2175XS Installation Instructions Manual

Remove Mounting Plate

NOTE: To avoid possible damage to the work surface, cover the
work surface.
1. Remove any remaining contents from the microwave oven
cavity.
2. Remove the mounting plate and set aside.
A
A. Mounting plate
B. Back of microwave oven
3. Tape the microwave oven door closed so that door does not
swing open while the microwave oven is being handled.
NOTE: To avoid damage to the microwave oven, do not grip or
use the door or door handle while the microwave oven is being
handled.
4

INSTALLATION INSTRUCTIONS

B

Rotate Blower Motor

The microwave oven is set for recirculation installation. For wall or
roof venting, changes must be made to the venting system.
NOTE: Skip this section if you are using recirculation installation.
Keep the damper assembly in case the venting method is
changed, or the microwave oven is reinstalled in another location
where wall or roof venting may be used.
Wall Venting Installation Only
1. Remove screws attaching damper plate to top of microwave
oven exterior. Slide damper plate toward the front of the
microwave oven and lift up.
A Screws
B. Damper plate
2. Keep damper plate and screws together and set aside.
3. Remove 2 screws attaching blower motor to back of
microwave oven.
A
A. Screws (in recessed holes)
4. Lift blower motor out of microwave oven.
A. Blower motor
A
B
A