Power Fist 9149642 Quick Start Manual

V1.0

SPECIFICATIONS

Cutting Range 3 to 4 mm
Cutting Material Glass
Overall Length 5 in
Cutting Angle 0 to 180°
Handle Material Wooden
Notch Type Tungsten-carbide
Finish Chrome plated head, varnished wood
handle
Material Thickness 13 mm

SAFETY

WARNING! Read and understand all instructions
before using this tool. The operator must follow basic
precautions to reduce the risk of personal injury
and/or damage to the equipment.
Keep this manual for safety warnings, precautions, operating
or inspection and maintenance instructions.
1. Always wear impact safety goggles that provide front
and side protection for the eyes. Eye protection
equipment should comply with CSA Z94.3-07 or ANSI
Z87.1 standards based on the type of work performed.
2. Use the correct tool for the job. This tool was designed
for a specific function. Do not modify or alter this tool or
use it for an unintended purpose.
3. Control the tool, personal movement and the work
environment to avoid personal injury or damage to tool.
4. Do not operate any tool when tired or under the
influence of drugs, alcohol or medications.
5. Cut glass edges are sharp. Be careful when handling the
pieces.
Please read and understand all instructions before use. Retain this manual for future reference.

UNPACKING

WARNING! Do not operate the tool if any part is
missing. Replace the missing part before operating.
Failure to do so could result in a malfunction and
personal injury.
Remove the parts and accessories from the packaging and
inspect for damage.

OPERATION

Rotate the wheel to the next circular blade when the current
blade is dull.
1. Place the glass on a flat surface.
2. Draw a line on the glass with a ruler and marker.
3. Apply lubricant oil to the cutting wheel or dip the glass
cutter head in the lubricant. You can also choose to apply
a lubricant to the glass along the path of the cut.
4. Hold the glass cutter vertically with the head against the
ruler and the blade on the drawn line. Start the tool at
the edge of the glass.
5. Apply steady pressure and either push or pull the glass
cutter without stopping, until it rolls off the glass. You
will hear a grinding sound as the cutter scores the glass,
6. Snapping straight scores in glass.
a. Hold the glass in your hands with your thumbs on
top alongside of the score on either side. Sharply
rotate your hands downward in opposite directions
while maintaining your grip to separate the glass.
b. Use running or breaking pliers with the above
method in place of one hand.
i. Running pliers are for thick glass.
ii. Breaking pliers are for thin strips of glass that
you cannot hold with your hand.
c. Hang the score about 1/4 in. over a table edge. Press
the glass down on the table with one hand. Hold the
glass on the other side of the score. Lift the
overhanging glass several inches and abruptly bring
the glass down on the table edge to snap the glass
along the score.
7. Snap straight or curved scores in glass with either
method below.
a. Flip the glass pane over and lay it down on the
flat surface. Tap the glass in a steady rhythm
along the score with a rounded tool until the
glass separates.
b. Flip the glass pane over and lay it down on the
flat surface. Place your thumbs on either side of
the score and press down with straight arms. As
you hear the glass crack, run your thumbs along
the score until the glass separates.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is
efficient, easier to control and will have fewer problems.
2. Inspect the tool components periodically. Repair or
replace damaged or worn components. Only use identical
replacement parts when servicing.
3. Follow instructions for lubricating and changing
accessories.
9149642