Advertisement
5. ASSEMBLY/STORAGE INSTRUCTIONS
5.1
ASSEMBLY.
Note: Numbers in brackets refer to item numbers as shown in the parts diagram (Section 8, page 5).
Your crane is delivered assembled but in a folded condition. Before using, it is necessary to lay the folded crane on it's 'back' on the floor and
proceed as follows.
unpack the product and check contents against the parts list in these instructions. should there be any damaged or missing parts
contact your supplier immediately. We recommend two people assemble the crane as follows:
a) Lower the crane legs and lock them into place with the pins (18). retain the lock pins with the cotter pins (19).
b) rotate the assembled crane onto its wheels.
pump socket, pump 10-15 times through the full stroke, thus bleeding, from the hydraulic system, any air which may have entered
during transit.
5.2
STORAGe.
a)
Always store the crane fully closed so that the jib is in lowest position and the ram is closed.
b)
to save space the legs may be folded into the upright position and secured in place using the Lock Pins.
6. OWNER'S & OPERATOR'S RESPONSIBILITIES
The owner and/or operator shall study these instructions and
retain them for future use.
a)
Understanding instructions and warnings.
the owner and/or operator shall understand the operating
instructions and warnings before operating the crane.
Warning information must be emphasised and understood.
If the operator is not fluent in English, the product instructions
and warnings must be read to, and discussed with, the
operator in the operator's native language by the owner,
making sure the operator understands the contents.
b)
Damaged Cranes.
Any crane which appears to be damaged, badly worn, or
operates abnormally Must BE rEMoVED froM sErVIcE!
It is recommended that necessary repairs be made by an
authorised service agent.
c)
End of service.
through years of normal wear, the crane will eventually
become unserviceable. When this happens ensure the
hydraulic oil is drained off and disposed of in accordance with
local authority regulations.
7. DECLARATION OF CONFORMITY
Declaration of Conformity:
FOLDING WORKSHOP CRANE
MODEL No: PH10
2006/42/Ec Machinery Directive
93/68/EEc cE Marking Directive
Health & safety at Work Act 1974
Lifting operations & Lifting Equipment regulations (LoLEr) 1998
En292-2 1991
Your crane is guaranteed for one year from the date of purchase. the Guarantee does not cover faults caused by incorrect use, lack of
maintenance, accidental damage or damage caused to third parties through misuse. You are recommended to inform your insurers and check
that adequate cover is in place. Warranty claims must be supported by a copy of the dated purchase receipt.
NOTe: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
signed by Mark sweetman
For Jack Sealey Ltd. Sole importer into the UK of Sealey Power Products.
Sole UK Distributor
Sealey Group,
Bury st. Edmunds, suffolk.
Page 3
We, the sole importer into the uK, declare that the product listed
below is in conformity with the following standards and directives.
the construction file for this product is held by the Manufacturer
and may be inspected, by a national authority, upon request to
Jack sealey Ltd.
01284 757500
W e b
01284 703534
email
1st December 2007
www.sealey.co.uk
sales@sealey.co.uk
PH10 - (3) - 061207
Advertisement
