Table of Contents
Advertisement
Replacing the Drum
The microREEL APX case gives you the
ability to swap out the drum when the job
requires a different push cable and camera
combination. Ether drums on the SeeSnake
microDRAIN
APX and NANOreel
™
tems can be installed into the microREEL
APX case.
To install the drum, follow these steps:
1. Open the microREEL APX case and
remove the drum.
2. Place the drum you want to use in the
microREEL APX case.
3. Make sure the product name label
faces up.
4. Spin the drum to make sure it rotates
freely.
5. Close and lock the case.
Maintenance and
Support
Cleaning the microREEL APX
Clean your system with rags and a soft
nylon brush. If desired, a mild detergent or
disinfectant can be used. Do not use sol-
vents or high pressure water to clean any
part of the system.
Maintaining Components
Camera Head
Scratches on the camera have a minimal effect
on its performance. Do not use scraping tools
or sand the camera to remove scratches.
Push Cable
Run a rag over the push cable and visually
inspect it for cuts and abrasions while push-
ing it back into the drum. Replace or repair
the push cable if the outer jacket is cut or
abraded.
Storage
Store your equipment in dry, secure area
out of the reach of children and people un-
familiar with its purpose. The microREEL
APX must be stored between -20°C and
sys-
70°C [-4°F and 158°F]. The CSx Via must
™
be stored between -20°C to 60°C [-4°F to
140°F]. Store away from heat sources such
as radiators, heat registers, stoves, and
other products (including amplifiers) that
produce heat.
Transport
Remove the battery before shipping and
before storing for extended periods of time
Do not expose to heavy shocks or impacts
during transport.
Support
For support and additional information
about using your microREEL APX system,
visit support.seesnake.com/microreel.
For support and additional information
about using your CSx Via, visit support.
seesnake.com/csxvia.
microREEL APX / CSx Via – English – 13
Advertisement
Table of Contents
