Sony DAV-DX150 Operating Instructions Manual page 16

To connect the speaker cords
Connect the speaker cords after bending the bare wire at the end of the insnlation. This prevents the
speaker insnlation from being inserted in the speaker temlinaL
• Do not catch the speaker cord insulation in the SPEAKER jack
Avoiding short-circuiting the speakers
Short-circnitmg of the speakers may damage the system. To prevent this, be sure to follow these
precantions when connecting the speakers. Make sure the bare wire of each speaker cord does not touch
another speaker terminal or the bare wire of another speaker cord.
Examples of poor conditions of the speaker cord
Stripped speaker cord is Stripped cords are touching each
touching another speaker other due to excessive removal of
terminal, insulation.
After connecting all the components, speakers, and AC power cord (mains lead), output a test tone to
check that all the speakers are connected correctly. For details on outputting a test tone, see page 77.
If no sonnd is heard from a speaker while outputting a test tone, or a test tone is output from a speaker
other than the one currently displayed in the front panel display, the speaker may be short-circuited. If
this happens, check the speaker connection again.
• Be sure to match the speaker cord to the appropriate terminal on the components: @ to @, and @ to @. If the colds
are reversed, the sound will lack bass and may be distorted
Installing the satellite speakers on the wall
1
Prepare screws (not supplied) that are suitable for the hole on the back of each speaker.
See the illustrations below.
............ 4 mm (5/32 inch) 46 mm
(3/16inch)
25 mm (1 inch) 10 mm
Hole on the back of
the speaker
16c8