Grounding Instructions; Important Warning - Danby DIPLOMAT DCR033W Owner's Manual

Safety Instructions
ATTENTION
GROUNDING INSTRUCTIONS
This appliance must be grounded. In
the event of an electrical short circuit,
grounding reduces the risk of electrical
shock by providing an escape wire for the
electrical current. This appliance is
equipped with a cord having a grounding
wire with a grounding plug. The plug must
be plugged into an outlet that is properly
installed and grounded.
WARNING
- Improper use of the
grounding plug can result in a risk of electric
shock. Consult a qualified electrician or
serviceman if the grounding instructions are
not completely understood, or if the doubt
exists as to whether the appliance is
properly grounded.
DO NOT USE AN EXTENSION CORD
Use an exclusive wall outlet. Do not connect
your refrigerator to extension cords or
together with any other appliance in the
same wall outlet. Do not splice the cord.
IMPORTANT WARNING
An empty refrigerator is a very dangerous
attraction to children. Remove either the
gasket, latches, lids or doors from unused
appliances, or take some other action that
will guarantee it harmless.
DANGER: Risk of child entrapment. Before you throw away
your old refrigerator or freezer.
• Take off the doors
• Leave the shelves in place so that children may
not easily climb inside.
DON'T WAIT DO IT NOW!
Installation
Remove the exterior and interior packings, wipe
the outside thoroughly with a soft dry cloth and
the inside with a wet, lukewarm cloth. Avoid
placing the cabinet in a narrow recess or near
any heat source, direct sunlight, or moisture.
Let air circulate freely around the cabinet. Keep
the rear of the refrigerator 5 inches away from
the wall.
Location
1. Select a place with a strong, level floor.
2. Allow 5 inches of space between the back of
the refrigerator and any adjacent wall.
3.
Avoid direct sunlight and heat. Direct
sunlight may affect the acrylic coating.
Heat sources nearby will cause higher
electricity consumption.
4. Avoid very moist places. Too much moisture
in the air will cause frost to form very quickly
on the evaporator, and your refrigerator will
have to be defrosted very frequently.
Operation
To avoid vibration, the cabinet must be set level.
To start the refrigerator, turn the temperature
control to the position corresponding to the
desired cooling. The refrigerator temperature
will vary depending on the quantity of the food
stored and on the frequency with which the door
is opened.
Turn the control to the "O " position to
temporarily disconnect the cooling cycle. After
defrosting and if the refrigerator has been left out
of use for some time, set the control to maximum
for 2 to 3 hours before turning to the desired
position. When the refrigerator is not to be used
for a long period of time, disconnect the plug and
leave the door partially open.
Note: Wait 3 to 5 minutes before restarting if
operation has been interrupted
Ice Cube
Tray
Ice cube tray is flexible. Twist tray to remove
ice cubes. If the ice cube tray is frozen hard to
the evaporator surface, run a little water over the
tray. Never use a knife or other metal instrument
to remove ice cube tray because this may
damage the evaporator. (Fig. C)
Fig. C
2